Summary of Contents for MK Diamond Products MK-2000P
Page 1
MK-2000P HAND HELD WET CORE DRILL OWNER’S MANUAL & OPERATING INSTRUCTIONS CAUTION: Read all safety and operating instructions before using this equipment Enter the Serial Number of your new drill in the space below. The Serial Number is located on the casing of the drill.
Use metal detection systems if needed. 3. Check the MK-2000P for damage prior to use. Inspect the cord and plug for cuts, frays and damage. Have damage repaired by authorized repair technicians. Take care that the ON/OFF switch is in the OFF position before inserting the plug into a power receptacle.
Page 3
When the Acoustic Overload Warning is heard, it is recommended that the operating speed and applied pressure be immediately reduced, and/or, the core bit be operated under a no-load condition. NOTE: If the MK-2000P stops due to the activation of one of the overload protective devices, this should not be considered an equipment failure.
(Part Number 158490) Water Supply: The MK-2000P is equipped with an intake cooling water flow control valve that can be placed vertically or horizontally. A quick disconnect is supplied with the unit for ease of operation. Water flow enters through the flow control valve and exits directly through the center of the motor shaft.