Assembly - activecare medical Spitfire 1310 Owner's Manual

For service assistance, please call your authorized ActiveCare dealer.
Suggestion
1. It is recommended that you charge the battery immediately when the
battery gauge is in the red area.
2. After charging or replacing a new battery, drive the scooter for 2-3 minutes
to make sure the battery capacity is enough.
3. In the wintertime, the battery may respond more slowly and the distance
you can travel may also be shortened.
4. When driving on an incline, the battery gauge light might move from green
to red, this is a normal phenomenon, please do not worry.
5. Even if the battery is used properly, it is natural that the battery capability
will decay as time passes. This results in a shortening of travel distance
compared to a brand new battery. Therefore, when you find the travel
distance is about only 50% of a brand new battery's traveling distance, it is
time for a replacement battery. Please go to your dealer and ask a new
battery. If you continue to use the old battery when its capacity has
decreased, it could lead to a decrease in travel distance.
6. Travel distances will be shortened when driving frequently on an incline or
slope, as this leads to a larger consumption of the power.

ASSEMBLY

No tools are required to disassemble or assemble your scooter.
1. Place the freewheel mode lever in the drive position.
2. Set the rear section in the up position and make sure the hook for the front section is
connected to the axle of the rear section. (See Fig. 1)
3. Put down the front and rear sections until the scooter is level. (See Fig. 2)
4. Set down the battery pack on the scooter, and make sure it is in the correct position.
5. Set down the seat on the seat post until the swivel lock engages and you hear a click.
6. Turn key switch to "ON". Make sure battery gauge indicates sufficient power.
9
Fig. 1
Spitfire 1310/1410 Owner's Manual
Fig. 2