Ten-Tec 1253 Assembly And Instruction Manual page 50

PHASE 7.0: FINAL ASSEMBLY STEPS
7-58. Attach the battery shelf assembly to the rear panel
using two #4 self-tapping screws inserted from the back end of
the rear panel. (This procedure is done MUCH more easily
without the weight of batteries.)
7-59. Re-install the 8 "C" cells, if desired.
7-60. Attach the 4 self-stick rubber feet to the four corners of
the bottom shell, making allowance for all slots to accommodate
screw heads from the panel/chassis section.
7-61. Set the receiver chassis/panel assembly into the bottom
shell prepared in step 7-60 above.
7-62. Check ALL wires and cable-tied groups to make sure
they are not jammed tightly against hardware or parts.
7-63. Secure the top shell with speaker to the bottom shell
with the four short #6 sheet-metal screws.
7-64. Turn the receiver on, simply to ensure proper operation
of the bandswitch button. If the band switching behaves
erratically or not at all, this is an indication that the subpanel is
mounted too far forward, or that the front panel is being bent
back by the main tuning knob being mounted too close to the
front panel, or that the top shell is not aligned correctly.
Adjust as needed.
These steps for Phase 7, followed exactly and in order, complete
the assembly of the T-KIT 1253 Shortwave Receiver. When or if
necessary, the receiver can be disassembled by following these
same steps in reverse order.
Be sure to study the following explanations of all controls and
connections to achieve maximum understanding and enjoyment
of the receiver. Especially, make certain to familiarize yourself
with the use of the Regeneration and RF Gain controls.
1253 - 48