Table of Contents
Advertisement
Chapter 5: DVR Setup -
If a channel is disabled, the system will display "OFF" on the monitor, this channel
will not be displayed or recorded. Refer to 5.3 Record Select
Chapter 5: DVR Setup -
This option allows you to select which channels will be recorded.
Note: If no channels are selected an error message saying "record fault" and "no
record channel" will appear briefly on the screen when the record button is pressed
or scheduled / motion recording is started.
Chapter 5: DVR Setup -
There are two modes of operation for recording resolution:
1. EACH MODE:
The DVR compresses and records each video channel separately so you can
enlarge a single channel to a full screen display whilst still recording on all
channels. In this mode you can also record specific channels, for example, you
could turn off recording on CH1 and CH2 and the system would only record video
on CH3 and CH4.
Press [CH1], [CH2], [CH3] or [CH4] to enlarge that channel to a full screen
display.
In EACH Mode you can also use the Auto Switch Function.
5.2 Camera Select
The DVR can display 4 cameras in
the one screen (Quad Mode).
Each channel can be enabled /
disabled in case one or more camera
inputs are not being used.
Press [ SEL] to modify this setting,
or press [CH1] - [CH4] to view each
channel separately.
5.3 Record Select
5.4 Resolution
6
Hide quick links:
Advertisement
Table of Contents
