Using Homelink; Security - Chrysler 1500 Owner's Manual

216 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
If you unplugged the garage door opener/device for
programming, plug it back in at this time.
Reprogramming A Single HomeLink® Button
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink® button until
the EVIC displays "CHANNEL # TRAINING" Do not
release the button.
3. Without releasing
"Canadian/Gate Operator Programming" Step 2 and
follow all remaining steps.
Using HomeLink®
To operate, press and release the programmed
HomeLink® button. Activation will now occur for the
the button proceed
programmed device (i.e., garage door opener, gate opera-
tor, security system, entry door lock, home/office light-
ing, etc.,). The hand-held transmitter of the device may
also be used at any time.

Security

It is advised to erase all channels before you sell or turn
in your vehicle.
To erase the channels press and hold the two outside
HomeLink® buttons (I and III) for up 20 seconds. The
Electronic Vehicle Information Center (EVIC) will display
"CLEARING CHANNELS." Release the buttons when
with
the EVIC displays "CHANNELS CLEARED."
The HomeLink® Universal Transceiver is disabled when
the Vehicle Security Alarm is active.