Tuning In Tv; Digital Switchover Re-Tune; Getting Started - Initial Set Up - Vision Plus X156/44C-GB-TCD-UK User Manual

156_44 english manual 10.pdf 28. 5. 2009 12:02:25

GETTING STARTED - INITIAL SET UP

IMPORTANT - AFTER TUNING DO NOT PRESS ANY BUTTONS FOR 20 SECONDS SO THE CHANNEL
TUNING IN
IMPORTANT — Please ensure the TV has
reached room temperature before
connecting the power for the first time
1) Connect the mains lead to your electrical outlet
and connect the power adaptor to the television.
POWER
DC 12V
2) Connect the RF cable supplied to the
'RF IN' on the rear of the TV and connect
the other end of the cable to your TV Aerial outlet
POWER
DC 12V
3) Install batteries in the remote control and press
the [STANDBY] button to turn on the TV.
The 'First Time Installation' menu should
now appear. If it does not, please press
[LCD-MENU] then 8-8-8-8 and the menu will appear.
4) Press [OK] on the remote control whilst 'OK'
is highlighted on screen.
First Time Installation
Country
Language
Please ensure that the aerial is connected to the connector
labelled ' RF In ' on the rear of the TV .Ensure that OK is
highlighted in yellow and press 'OK' on your remote .If after
this scan ,not all digital channels are found ,your aerial may
require a signal booster .alternatively ,upgrade your aerial
to a high gain digital version .
OK
Tuning will now take place.
If the TV finds some, but not all, of the Digital channels, the TV is functioning
correctly but the signal being received is not strong enough. (The signal strength
needs to be above 85% - you can see the signal strength the TV is receiving when
you change channels/ programmes) you will need to increase the signal reception
in order to receive all of the channels available.
To improve signal reception whether at home or on the move it may be necessary
to upgrade or enhance you existing TV aerial. For advice and assistance on
Vision Plus Aerials and Accessories please contact:-
10
INFORMATION CAN BE STORED.
RF IN
RF IN
INFO
UK
English
Cancel
Grade UK Limited on 0115 986 7151.
If no channels are found the following screen will appear,
please refer to additional information below.
First Time Installation
Unfortunately the TV did not find any channels
Please check your aerial connection
and refer to the user manual
Do you wish to re tune your TV
Yes Do it next time
TYPICAL SET-UP
Connect between TV and TV
Aerial socket
Once you have connected a 'Signal booster' you will need
to retune the TV in order to receive all of the channels.
No
Signal Booster