Cpu Removal - Toshiba Satellite 5200 Series Replacement Manual

FIELD REPLACEABLE UNIT DOCUMENTATION

CPU REMOVAL

Open
Close
CPU lock
1. Insert a flat head screwdriver in the CPU lock and
rotate it counter-clockwise to unlock the CPU.
2. Lift out the CPU.
NOTE: When installing the CPU, make sure that a silicone
grease is applied before attaching the heat sink.
Please refer to FSB-200112 for the complete
procedures on how to apply the silicone grease.
USB BOARD REMOVAL
USB board USB I/F harness
1. Disconnect the USB I/F harness from PJ6200 on the
system board.
2. Remove two M2x4 black screws securing the
USB board.
3. Lift out the USB board.
Satellite
5200 Series
CPU
Silicone
grease
M2x4
black
screws
PJ6200
TOSHIBA
Tough Enough for Today's World
TM
TOSHIBA STYLE BAY REMOVAL
Style
bay
M2x3 flat head silver screws
1. Remove two M2x3 silver flat head screws securing
securing the TOSHIBA style bay.
2. Gently lift up the TOSHIBA style bay.
SYSTEM BOARD REMOVAL
DC IN
jack
Battery
cover
Plastic tape
Heat shield
1. Peel off the plastic tape securing the HDD FPC and
lift out the heat shield.
2. Disconnect the RJ-45 jack cable from PJ108 on the
system board and detach the DC IN jack from its slot.
4. Release two latches securing the battery cover and
remove the cover.
RJ-45 jack cable