Table of Contents
Advertisement
4
Press Next to select the port assignment that you want to change. The
active port setting will flash. The active timeslots move left to right in a
cycle. Pressing Next after activating timeslot 4 will scroll to timeslots
5-8. Pressing Next after activating timeslot 24 will cycle back to
timeslot 1. To back up, start over.
5
To reset a timeslot, press Enter until the desired port assignment
displays.
6
Repeat
Step 4
change.
7
When you have made all your changes, press Enter. The system prompts
you to confirm your changes.
8
Press Enter to confirm your changes and return to the
you wish to return to the
press Escape twice).
If both the DSX-1 and one or more of the data ports are
mapped to HDSL timeslots, do not turn off the DSX-1 input
while power is applied to the Campus-Flex RS Interface Card.
See the required procedure in
Campus-Flex RS Interface Card User Manual
and
Step 5
for each port assignment that you want to
DS-0s
Setting Up the Campus-RS System
display without confirming the changes,
"Data Port Failure" on page
display (if
DS-0s
8-5.
3-5
Advertisement
Table of Contents
