Table of Contents
Advertisement
43-738.fm Page 31 Friday, August 13, 1999 1:51 PM
ERASING MESSAGES
The TAD records new messages over
any old messages you do not want to
save. But, you can erase all stored
messages on a tape at one time. This
is convenient if you want to use tapes
you used in the TAD in other recording
devices, or to prevent others from play-
ing your messages again.
Note: You must use the controls on
the base to erase messages.
1. Play the incoming messages.
When the TAD has played back
the last message, press and
release
ERASE/STOP
2. While pressing and holding down
, press
ERASE/STOP
TAD rewinds the tape, then era-
ses all the messages (up to the
end of the new messages). After
the TAD finishes erasing the tape,
it rewinds the tape to the begin-
ning and stops.
Notes:
• The TAD will not answer calls
while it is erasing messages. If the
TAD is set to receive calls, press-
ing
ERASE/STOP
to answer calls.
• To stop erasing messages, press
again.
ERASE/STOP
• If you receive a call while erasing,
press
TALK
on the handset or lift
the handset from the cradle to
.
. The
REWIND
sets the TAD not
answer the call. After the call,
repeat Steps 1-2 to continue eras-
ing the messages.
RECORDING A MEMO
You can use the TAD to record a re-
minder for yourself or a message for
someone in your home or office. You
can record a memo using either the
base or the handset.
Note: When you record a memo, the
TAD saves the memo on the incoming
message tape like other recorded
messages.
Using the Base
Follow these steps to record a memo
at the base.
1. Press
. The TAD beeps for
MEMO
about 2 seconds, and the MEMO
indicator lights.
2. After the TAD stops beeping,
begin recording the message.
Speak in a strong voice from
about 12 inches away from the
front of the TAD.
31
Advertisement
Table of Contents
