Rear Panel - US Blaster USB 7132 Owner's Manual

USB 7132 / 7133 / 7134
Professional Power Amplifier

REAR PANEL

1. Fan
The fan operates continuously while the amp is on. An internal temperature sensor increases the
speed of the fan during high temperature conditions. Air enters through the rear of the amp and
exits through the front grill. Be sure to allow adequate air flow from the rear of the rack where the
amp is mounted on.
2. Mode Selector Switch
The two-position mode switch configures the amplifier for. Stereo or Bridged Mono operation. The
default factory setting is Stereo. See operation modes .
3. Input Connections
Input signals can be connected to the amp via the Phoenix connectors, The 1/4" TRS connectors
and the Female XLR (pin 2 hot) connectors. Power. See Connections .
4. Output Connections
Speakers can be connected via the high current binding posts and the industry -standard Speakon
(NL-4) connectors. Binding posts: One pair (Red- hot, Black- ground) per channel. Speakons: One
connector for each channel. In Bridged Mono mode, the Speakon connector for Channel 1 is used
exclusively. See Connections.
5. Ground Termina
For your safety purpose, please make sure ground terminal is grounded before using.
6. Power Cord
Build-in AC power cord with plug.
7. Fuse
USB 7132 T3.15A-230V/50Hz
USB 7133 T4A-230V/50Hz
USB 7134 T8A-230V/50Hz
Note : fuse for USB 7134 is located at power supply board.
© US Blaster Europe BV
Fuse
Fuse
Built-in fuse