Safety Information - US Blaster USB 7132 Owner's Manual

USB 7132 / 7133 / 7134
Professional Power Amplifier

SAFETY INFORMATION

1) Read these instructions and keep it in a handy place for future reference.
2) Be sure to follow all instructions and heed all warnings
3) Clean only with a dry cloth.
4) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
5) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
that produce heat.
6) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has
two blades with one wider than the other. A grounding-type plug has two blades and a third groun-
ding prong. The wide blade or the third prong is provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
7) Protect the power cord from being walked on or pinched, particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
8) Only use attachments/accessories specified by the manufacturer.
9) Use only with a cart, stand, bracket, or table specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving the cart/ apparatus combination to avoid
injury from tip-over.
10) Unplug this apparatus during lightning storms or when unused for long periods of time.
11) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
DO NOT REMOVE COVERS. NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
THIS EQUIPMENT MUST BE GROUNDED. SHOULD NOT BE NECESSARY TO
REMOVE ANY PROTECTIVE GROUND OR SIGNAL CABLE SHIELD CONNECTI-
ONS TO PREVENT GROUND LOOPS. ANY SUCH DISCONNECTIONS ARE OUT-
SIDE THE RECOMMENDED PRACTICE OF GROUND AND WILL RENDER ANY
EMC OR SAFETY CERTIFICATION VOID.
For continued compliance with international EMC legislation ensure thatall input
cables are wired with the cable screen connected to Pin 1 of the XLR connectors
and/or the jack plug sleeve.
WARNING! This equipment can create high sound levels. Exposure without
adequate protection could cause permanent damage to hearing.
© US Blaster Europe BV