Advertisement
INSTRUCTIONS TO DC TIG:
1. Make "AC/DC" to "DC" place.
2. PULSE/DC switch, if you put it at PULSE, you can adjust the buttons for Base
current adjustment. Set pulse adjustment or clear width adjustment to
achieve the welding efficiency that you need.
3. Turn on the power switch, the fan inside the machine begin to work.
4. Turn on the gas switch; adjust the gas to rated standard. (See parameter)
4. Same as ACTIG welding instructions 5. 6. 7. 8.
Any plug-in or plug-out of cable or connection during the welding is forbidden,
because such operation may cause harm to either body safety or the
equipment.
Cautions & Pre-cautions
Environment
1)
The operation should be in a comparative dry environment, the air humidity
no more than 90%.
2)
The around temperature should be between -10°C and 40°C.
3)
Avoid working under the sun or in the rain, do not let in water or rain.
4)
Avoid working under the circumstance of dust or air with corrosive gas.
5)
Avoid doing C02 working under the condition of strong air flow.
CAUTIONS
10
Advertisement
