K&M Analog Designs Two-Rock Topaz Owner's Manual page 4

10. 2ROCK/HI-FI- This switch allows you to choose between 2 completely
different equalization setting. HI-FI is a lower gain setting, with extended
midrange and bass available when used in conjunction with the middle and
bass controls as well as the deep switch. This setting is suitable for any style
requiring a pure clean tone with a nice round bottom and plenty of
headroom.
2ROCK is a higher gain setting , allowing a greater signal level to pass to the
lead channel. This setting is suitable for any style requiring a clean to
slightly distorted tone in clean mode , and more gain in the lead mode.
11. LEAD GAIN- Adjusts the input level (gain) of the lead channel.
At lower settings, a slightly overdriven tone can be achieved.
As the control is adjusted clockwise, the overdrive effect increases.
12. LEAD MASTER- Adjusts the output level of the lead channel.
13. LEAD CHANNEL SWITCH- Sends the instrument signal through the lead
circuit, adding extra stages of gain to the signal and enabling the lead gain
and lead master controls. To enable foot switch control of this function,
switch must be in the down position.
14. BYPASS SWITCH- This switch bypasses the tone controls, increasing both
level and mid-range response.To enable foot switch control of this function,
switch must be in the down position.
15. REVERB- Mixes the dry signal with a high quality spring-type
reverberation effect. This effect is defeated with the control in the full
counter-clockwise position.
16. PRESENCE CONTROL- Adjusts the contour of high-frequency
response. The high-frequency response will increase as you advance the
control clockwise.
17. STAND-BY SWITCH- Should be in the "down" or "stand-by" position when
you apply power to the unit. After a few seconds, place the switch in the
"up" position to use the amplifier. You may leave the unit "powered up"
and place this switch in the "stand- by" position to mute the output.
18. POWER SWITCH- Turns the power on.
19. INDICATOR LAMP- This lamp will illuminate when the power switch is in
the "up" position, indicating the unit is receiving A/C power.
NOTE: All switches are ON in the "up" position.
Page 3