Basic Commands (Direct Access); Arm; Disarm - Viper 5806V Owner's Manual

Basic Commands (Direct Access)

No confirmation LED's on.

Arm

Press and release
The alarm arms, doors lock (if connected), and the siren chirps and
parking lights flash once. The Arm LED and beeps play to confirm. If
Valet mode* is On, the doors lock and the Arm LED and a fault tone
plays. Exit Valet mode to arm the alarm normally.
If a trigger zone fault is detected the siren chirps once again and the
remote will emit a Trigger Zone Fault Report**, the Arm LED and a
fault tone plays.
To Arm and Panic
Press and hold
The alarm Arms (or Locks in Valet) and, after two seconds, sounds
the siren and flashes the parking lights. The confirmation LED's
flash and siren tones play to confirm. Press the
to stop the output.

Disarm

Press and release
The alarm disarms, doors unlock (if connected), and the siren chirps
and parking lights flash twice. The Disarm LED and beeps play to
confirm. If Valet mode* is On, the doors unlock and the Disarm LED
and fault tones play.
An Alarm Report** will replace the disarm output if the alarm was
6
AUX
AUX
AUX
AUX
AUX
AUX
or
AUX
© 2013 Directed. All rights reserved.
button
AUX
AUX
AUX