Wall Mounting - Cisco 200 Series Quick Start Manual

Wall Mounting

The switch should be mounted so that the ports face up or down.
N
OTE
Do not mount the switch with the ports to the side, as this causes strain
on the connections.
There is a wall-mount kit packed with your switch. The dimensions for the
mount kit are as follows:
2
1 0.4 in/8 mm
Mount the smart switch to the wall by drilling two pilot holes 95 mm (3.7
inches) apart, attaching the provided anchors and screws to the wall, then
sliding the switch into position on the screws.
The switch must have a minimum of 5 inches (130 mm) of clearance on all
sides.
Insecure mounting might damage the device or cause injury.
W
ARNING
Cisco is not responsible for damages incurred by insecure wall-
mounting.
200 Series 8-Port Smart Switches
1
2 0.9 in/22.2 mm 3 0.3 in/6.8 mm 4 0.7 in/17.6 mm
3
4
3