Scene Double SDBX/S2-1 User Manual page 25

Remote Unit Configuration & Operation
3. Select the video channel you want to configure using one of the following
keys (not on the numeric keypad):
Channel Command
Select Channel 1 For Adjustment
Select Channel 2 For Adjustment
Select BOTH Video Channels
Use Channel 0 to tune both video channels simultaneously. This simplifies
the procedure for setting up dual-head installations where a consistent
cable type is used and the adjustments required should be almost the same.
4. Reset the selected channel(s) by pressing:
5. Step through the Assisted EQ settings to find the level that gives the best
image.
Assisted EQ Command
Next Assisted EQ Setting
Previous Assisted EQ Setting
Assisted EQ steps through a table of preset LF & HF EQ values for
different lengths of cable (in 25m increments calibrated from 0 to 375m).
Each time you enter Command Mode and start adjusting Assisted EQ, the unit
resets LF and HF values.
After finding the best setting, you will probably want to fine-tune the LF and HF
equalization settings (see steps 8&9). This is best done after adjusting for any
color skew as described below.
<Left Control> + <Home>
Key Sequence
<Left Control> + <PgUp>
<Left Control> + <PgDn>
Key
<1> (default)
<2>
<0> (Channel 0)
23