Genesis Air 2006D&L Installation And Operation Manual

Advertisement

Quick Links

GENESIS
AIR
2006D&L
I
O
NSTALLATION AND
PERATIONS
M
ANUAL
PLEASE READ AND SAVE THESE INSTRUCTIONS!
EPA
FIFRA87447-TX-001
CARB G-11-040
8901-NV-001

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2006D&L and is the answer not in the manual?

Questions and answers

Summary of Contents for Genesis Air 2006D&L

  • Page 1 GENESIS 2006D&L NSTALLATION AND PERATIONS ANUAL PLEASE READ AND SAVE THESE INSTRUCTIONS! FIFRA87447-TX-001 CARB G-11-040 8901-NV-001...
  • Page 2 OPERATIONS AND MAINTENANCE SCHEDULE This manual will guide the maintenance personnel in installing and servicing the Genesis Air 2006D&L unit. ……………………………………………………………………3 INTRODUCTION ……………………………………………………………………4 INSTALLATION WIRING DIAGRAM ……………………………………………………………………4 ……………………………………………………………………4 MAINTENANCE ……………………………………………………………………………4 LAMPS ……………………………………………………………………………4 GENERAL ……………………………………………………………………4 INSPECTION ……………………………………………………………………………5 REMOVAL DISPOSAL ……………………………………………………………………………5 ……………………………………………………………………5 INSTALLATION CATALYST ……………………………………………………………………………5...
  • Page 3 INTRODUCTION The Genesis Air 2006D&L is a stand-alone unit used to reduce the levels of Volatile Organic Compounds (VOC’s) and viable airborne biological contaminants. The unit is utilized as a “point-of-use” air purifier. The 2006D&L uses two 2” catalyst panels and two 2”...
  • Page 4  Open the front grille and remove the air filter and UV shield/catalyst assembly.  If a lamp appears blackened at one end, replace the lamp with a Genesis Air UVCHO18W. Ensure each lamp is plugged in firmly to receptacle.
  • Page 5  If the clear plug does not emit any glow, the problem may be in the ballast or wiring. Call your Genesis Air Representative for assistance. REMOVAL  Power the Genesis Air unit down using the kill switch or breaker to unit.  Open the front grille and remove the air filter and UV shield/catalyst assembly.
  • Page 6 The ballast supplies power to the lamps. It is located in the 2006D&L unit, where power enters the unit. If a lamp is unlit and a new lamp attached to the same harness will not light, the ballast may be at fault. If a ballast failure is suspected, contact Genesis Air for replacement options.

Table of Contents