Configuring The Patrol - HIKVISION DS-2AE714 User Manual

IR Speed Dome User Manual
Far LED Current refers to the strength of the far IR LED.
Note: The near LED current function is only supported by a certain camera model series.
 LED Control
Auto, Close, All On, Far On, Near On are selectable according to the different environment
demands.
 Fan Control
It is used for the fan control of the IR LED, and you can set it to ON, OFF, TEMP.
 Switch Delay
Switch delay refers to the dwell time it takes to adapt to the environment when the day mode
switches to the night mode.
 Heat Control
Heat control is used for avoiding the lens blur caused by the humidity entering into the internal
of the camera during the installation, which come to be the fog when the internal temperature
is quite will differ from the outside temperature. The heat control can warm the camera to fit
the cold whether better.

3.2.5 Configuring the Patrol

Purpose:
A patrol is a series of dome scanning actions between the preset positions. You can call a patrol to
scan the scenes automatically among a group of configured presets in sequence.
Steps:
1. Move the cursor to enter patrol configuration interface:
MAIN MENUS > DOME SETUP> PATROLS
2. Choose the Patrol Number.
Steps:
(1) Move the cursor to PATROLS NUM and click IRIS+ to enter edit mode.
(2) Click the up and down direction buttons to select the number of the patrol which is to be
configured.
(3) Click IRIS+ again to confirm and exit edit mode of this column.
Note: You can configure up to 4 patrols.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
PATROL SETUP
!!PATROL NUM
PATROL SETUP
PREVIEW PATROL
DELE PATROL
BACK
Figure 3-9 Patrol Configuration Menu
1
EXIT
12