Sharp Aquos LC-26D40U Operation Manual page 17

Watching TV
Method 1
Using CH
A
I'V
on the remote control unit or on the
TV.
EXIT ~RETURN
O~O
- FAVORITE CH -
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
• When you enter 0-9 only, channel selection will be made
if there is no operation within a few seconds.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press
5~ENT
• FLASHBACK will not work if no channel has been
changed after the TV is turned on.
Method 3
Using remote control buttons 0-9, • (DOT) to select
channels for VHF/UHF/CATV/DIGITAL.
Method 2
1 Press FLASHBACK to switch to the previously
tuned channel.
2 Press FLASHBACK again to switch back to the
currently tuned channel.
MUTE
o
CH
• •
INPUT FLASHBACK
o
FREEZE MENU
0c::::I:::::>0
888
VOL
SURROUND
j+)
oU
You can change channels in several ways.
AQuas
To select a 3-digit channel number
(e. g., Channel 115):
Press 1~1~5~ENT
To select a 4-digit channel number
(e. g., Channel 22.1):
Press
2~2~
• (DOT)
~1 ~ENT
SH.4RP
• When you enter
0-9
only, channel selection will be made
if there is no operation within a few seconds.
• If you push "0" by itself, nothing will happen.
• Complete the above steps within a few seconds.
• When you enter 0-9 and • (DOT), channel selection will
be made if there is no operation within a few seconds.
@-16