Installing An Adapter - IBM 4190 User Manual

2. Turn off the server and all attached devices (see "Turning off the server" on
3. Disconnect all external cables and power cords.
4. Remove the server from the rack and place it on a flat, static-protective surface.
5. Press the cover-release button.
6. Slide the cover back approximately 1.27 cm (0.5 inches); then, lift it off the
Attention:
the server. Operating the server for extended periods of time (more than 30
minutes) with the cover removed might damage server components.

Installing an adapter

The following notes describe the types of adapters that the server supports and
other information that you must consider when you install an adapter:
v Locate the documentation that comes with the adapter and follow those
v The adapter slots are on the riser-card assembly. You must first remove the
v The two PCI Express slots on the riser-card assembly support PCI Express x8
v You can install one full-height three-quarter-length adapter in expansion slot 1
v If you have installed an optional PCI-X riser-card assembly in the server, you can
v An optional Remote Supervisor Adapter II SlimLine can be installed only in the
page 10).
Cover-release
button
server.
For proper cooling and airflow, replace the cover before you turn on
instructions in addition to the instructions in this section. If you have to change
switch settings or jumper settings on the adapter, follow the instructions that
come with the adapter.
riser-card assembly to access the adapter slots.
1.0a adapters.
and one low-profile half-length adapter in expansion slot 2.
Note: When the optional Remote Supervisor Adapter II SlimLine is installed in
the server, you can install only a half-length adapter in expansion slot 1.
install a full-height, three-quarter-length PCI-X 64/133 MHz adapter in the PCI-X
slot on the riser-card assembly.
Note: When the optional Remote Supervisor Adapter II SlimLine is installed in
the server, you can install only a half-length adapter in the PCI-X slot.
dedicated connector on the system board (see "System-board optional-device
Chapter 2. Installing optional devices
23