Advertisement

User’s Manual
Version 1.0
September 2002

Advertisement

Table of Contents
loading

Summary of Contents for Behringer V-amp pro

  • Page 1 User’s Manual Version 1.0 September 2002...
  • Page 2 V-AMP PRO SAFETY INSTRUCTIONS...
  • Page 3: Table Of Contents

    1. INTRODUCTION ............4 2. CONTROL ELEMENTS ..........4 3. EXAMPLES OF USE/OPERATING MODES (CONFIGURATION) ........... 7 4. V-AMP PRO PRESETS ..........8 5. AMP/SPEAKER SIMULATION ........9 6. EFFECTS PROCESSOR ..........11 7. TUNER ..............12 8. INSTALLATION ............12 9.
  • Page 4: Introduction

    V-AMP PRO 1. INTRODUCTION 2. CONTROL ELEMENTS 2.1 Front panel Fig. 2.1: V-AMP PRO front panel (section 1) 1.1 ... before you get started POWER GAIN VOLUME BASS TREBLE AMPS 1.1.1 Serial number 1. INTRODUCTION...
  • Page 5 V-AMP PRO TUNER BANK DOWN BANK UP Fig. 2.2: V-AMP PRO front panel (section 2) MIDI DRIVE Fig. 2.3: V-AMP PRO display CABINETS Tab. 2.1: Output formats and display LED assignments REVERB DISPLAY NOISE GATE 2. CONTROL ELEMENTS...
  • Page 6 V-AMP PRO 2.2 Rear panel Fig. 2.4: V-AMP PRO front panel (section 3) Fig. 2.5: V-AMP PRO rear panel (section 1) SEND/ LINE OUT REVERB RETURN/LINE IN EFFECTS ANALOG LINE OUTPUTS MASTER POST DSP INSERT RETURN (IN) GROUND LIFT DI OUT...
  • Page 7: (Configuration)

    V-AMP PRO 3. EXAMPLES OF OUTPUT CONFIGURATIONS Fig. 2.6: V-AMP PRO rear panel (section 2) 3.1 Selecting CONFIGURATION modes S/PDIF AES/EBU 3.2 Standard set-up with MIDI foot controller WORDCLOCK and (optional) recording system MIDI OUT/THRU MIDI IN 3.3 Hard-disk recording studio Fig.
  • Page 8: V-Amp Pro Presets

    V-AMP PRO 4.1 Calling up presets 3.5 Live set-up with P.A. system and your own guitar amp on stage 4. V-AMP PRO PRESETS Fig. 4.1: Calling up presets Tab. 4.1: V-AMP PRO modes with application examples 4. V-AMP PRO PRESETS...
  • Page 9: Amp/Speaker Simulation

    V-AMP PRO 4.2 Editing presets 5. AMP/SPEAKER SIMULATION 4.3 Storing presets 5.1 Amp descriptions 4.4 Discarding an edited preset/restoring a single factory preset Blow by Blow Wired 4.5 Restoring all factory presets 5. AMP/SPEAKER SIMULATION...
  • Page 10 V-AMP PRO 5. AMP/SPEAKER SIMULATION...
  • Page 11: Effects Processor

    Fender, Vox, Marshall, Mesa Boogie, Gibson, Soldano, Matchless, Dumble, Budda, Tweed, Engl, Roland and the names of musicians and groups are registered trademarks belonging to the respective owners and are in no way associated with BEHRINGER. 5.2 Speaker descriptions Reverb and delay algorithms 6.
  • Page 12: Tuner

    V-AMP PRO Special effects 8. INSTALLATION 8.1 Rack mounting 6.2 The separate reverb effect 8.2 Mains voltage 7. TUNER 7.1 Tuning your guitar 8.3 Audio connections 7.2 Setting reference pitch “A” 8. INSTALLATION...
  • Page 13 V-AMP PRO 8.4 MIDI connections Fig. 8.1: XLR connectors 8.4.1 Sending/receiving MIDI-Sysex data Fig. 8.2: 1/4" mono plug 8.5 AES/EBU and S/PDIF standards Fig. 8.3: 1/4" stereo plug Fig. 8.4: Stereo headphones 1/4" plug 8. INSTALLATION...
  • Page 14: Specifications

    Ω Ω Ω Ω BEHRINGER constantly strives to maintain the highest quality standards. Modifi- cations may be made, if necessary, without prior notice. The specifications and appearance of the equipment may therefore differ from those listed or illustrated. 9. SPECIFICATIONS...
  • Page 15: Midi Implementation

    V-AMP PRO 10. MIDI IMPLEMENTATION 0,', ,PSOHPHQWDWLRQ &KDUW )XQFWLRQ 7UDQVPLWWHG 5HFHLYHG 5HPDUNV Midi Channel 1-16 1-16 Mode Note Number Velocity After Touch Pitch Bender Control Change N (request only) Wah Pedal N (request only) Volume Pedal Amp Gain (0-127) Amp Treble (0-127)
  • Page 16: Warranty

    V-AMP PRO 11. WARRANTY 11. WARRANTY...

Table of Contents