ViewSonic VG700b Service Manual page 38

4. Firmware Programming
Notice:1.) The screen will become no video, but the power LED will twinkle. When the power
2.) Or you can use “data transfer switch” switch to another monitor when firmware
3.) Get into“Burn In Mode”(Ref.6-2), press any buttons besides “Power” button to
check the firmware version if it is correct.
5. Unplug Power Cord and plug it again.
6. After finish Firmware upgrade, you should do “All Mode Reset”.
(Ref.6-2),
7. Check Firmware version.
7-4
ViewSonic Corporation
LED stops, it means program complete. You have no way to wake up screen, you
should unplug power cord, and replug it. Press “Power” the screen will wake up.
programming. You will see the program rate of progress below the screen when
the program rate of progress until 100%, it means firmware upgrade procedure
is completed.
Confidential – Do Not Copy
VG700b