Using Your Refrigerator; Changing The Light Bulb - Kelvinator refrigerator Use & Care Manual

Using your refrigerator

This section tells you how to make the most of the many
useful features and how to clean them.
Door storage bins
Both refrigerator and freezer are fitted with door storage
bins. You can adjust the refrigerator bins to meet different
storage needs. All the door bins are completely removable
for cleaning. If you want to remove or adjust a bin, lift it
over the support lugs on the inner door panel. To replace,
push the bin down over the support lugs to lock it in place.
Crisper bin
You can use the crisper bin to store vegetables, fruit or
smallgoods. You can change the humidity inside the bin
by sliding the humidity control.
• S toring vegetables
You should store vegetables in the crisper bin remembering
to set the humidity control to more humid (closed).
• S toring fruit & smallgoods
You can also store fruit & smallgoods in the crisper bin
remembering to set the humidity control to less humid (open).
Using your refrigerator/Changing the light bulb Kelvinator Refrigeration
10
Changing the light bulb
Changing the light bulb – Side by Side fridge
1. Switch off the power at the power point and remove
the refrigerator's power cord from the power point.
2. Carefully unclip the light cover. You do this by inserting
your fingers behind the top of the light cover and pulling
it out while at the same time pushing it up at the bottom.
3. Pull the cover out until it is clear of the housing.
4. Unscrew the light bulb and replace it with a bulb that is
the same as the original. If, when you remove the light
bulb the small rubber "O" ring comes out with the bulb,
fit the "O" ring over the new bulb and screw bulb into
the socket (see diagram below).
N ever insert your finger into the light bulb socket
warning
to check for the presence of the "O" ring.
tips and information
Ensure the 'O' ring is in place before replacing
the bulb.
Light bulb
5. Replace the cover by inserting the tab back into place
and pushing in the cover with both hands at the top.
6. Wait 5 minutes to ensure pressures in the refrigeration
system are equalized. Then reconnect and turn the
refrigerator on at the power point.
Pull Pull
Push Push
"O" ring Light socket
Push Push
Tab Tab