Section 5: Securing the
Child in the Child Restraint
1
2
3
4
1. Loosen the harness
system. Press the
adjuster lever located
under the adjuster flap
and pull the shoulder
straps forward.
2. Open the chest clip by
squeezing tabs and
separating.
3. Open buckle by pressing
red button. Place harness
straps to the side or place
chest clip into harness
pocket to hold.
4. Seat the child in the child
restraint with his/her
bottom fully into the seat.
Position the harness
straps around the child
and fasten both latch
plates into the buckle.
14
5. Fasten chest clip.
5
6. Pull up on each shoulder
7. Tighten harness by pulling
6
7
8. The harness is tight
9. If you find the harness is
8
15
strap to tighten the lower
section of the harness.
adjuster strap straight out
through the adjuster flap.
The harness webbing
should be snug around the
child in both the lap and
shoulder sections. Slide
chest clip so it is at the
child's armpit level.
enough when you cannot
pinch a loop of webbing.
not tight fitting, an infant
insert may be required.
Please contact
1-888-9RECARO and
RECARO will ship you
an infant insert and
instructions.
Need help?
Do you have a question about the ProRIDE and is the answer not in the manual?