TABLE OF CONTENTS Introduction 1. Table of Contents page 2 2. Owners Record page 3 3. Planning a Location page 4 4. A Good Foundation page 5 5. Placing the Hot Tub page 5 6. Important Safety Instructions page 6 7.
Please read this “Owners Manual” carefully, as it is designed to provide you with the information you will need to ensure the safe, secure use of your new spa. IMPORTANT: Alps Spas & Alps Manufacturing reserves the right to change specifications or design without notification and without any obligation. alpsspas.com...
PLANNING A LOCATION FOR YOUR HOT TUB CONSIDER THESE THINGS WHEN DETERMINING WHERE TO PLACE YOUR NEW HOT TUB. SAFETY FIRST: Do not place the hot tub within 10 feet (3m) of overhead power lines. Make sure your hot tub is positioned so access to the equipment compartment and side panels will not be blocked.
A GOOD FOUNDATION Your new hot tub needs a good solid foundation. The area your hot tub sits on must be able to support the tub, the water in it and those who use it. If the foundation is inadequate, it may shift or settle after the hot tub is in place, causing stress to the shell or components.
IMPORTANT SAFETY INSTRUCTIONS It is the hot tub owner’s responsibility to read and follow all the instructions and precautions described in this manual. Failure to do so may result in personal injury. Liability rests with the hot tub owner. Please, make instructions available for reference by all hot tub users.
SAFETY PRECAUTIONS DANGER – RISK OF INJURY – READ AND FOLLOW ALL INSTURCTIONS 1. Read, keep, and make these instructions available! 7. Since excessive water temperature has a high potential for causing fetal damage during the early months of 2. Children should be CLOSELY supervised at all times. pregnancy, pregnant or possibly pregnant women should limit spa water temperatures to 100°...
FEATURE OPERATIONS AIR CONTROL VALVE Located around the top of the spa are air control valves. The air control valve serves to regulate the amount of air mixed with the water when the jets are operational. Rotate the air control to “AIR” to achieve the maximum jet pressure and therapeutic action.
Alps Spas strongly discourages the use of chemicals that contain Hydrogen Peroxide. Hydrogen peroxide will eventually cause the light body and lenses (used on all spas) to become brittle and crack.
CLEANING OR WINTERIZING Every three to six months, depending upon the water condition, you may need to renew your water. CAUTION: READ THIS BEFORE DRAINING YOUR HOT TUB To prevent damage to the hot tub’s components, turn off power to the spa at the circuit breaker before draining the hot tub.
SPA MAINTENANCE FILTER CARTRIDGE MAINTENANCE Alps hot tubs use a screw in cartridge that is easily removed. When the filter cartridge is removed, make sure no objects fall into the filter cavity. They can cause obstructions to the water movement. Every two weeks, the filter cartridge must be cleaned to remove the objects and particles that have lodged in the cartridge pleats.
TROUBLESHOOTING PROCEDURES In the event your Alps hot tub is not working the way it should, please first review all the installation and operating instructions in this manual and check the message on the panel display. If you are still not satisfied it is working properly, please follow the appropriate troubleshooting instructions.
CABINET DRAIN INSTRUCTIONS DRAIN INSTRUCTIONS 1. Inset closed position 2. Extended closed position 3. Full extended closed 4. Open position for draining (pull out to fully extended position (attach garden (turn hose and fitting turn position and remove cap); hose in the full extended clockwise and insert place cap in safe place.
• All exposed wire must be INSTALLED IN CONDUIT and have proper connectors. • ALPS SPAS is not responsible for any mis-wiring of control panel. • All models require a 60 AMP GFCI. ALUMINUM WIRE WILL VOID WARRANTY! Swim Spa electrical requirements From main panel install a 60 AMP GFCI 220 breaker.
Need help?
Do you have a question about the XLS series and is the answer not in the manual?
Questions and answers