Page 1: Table Of Contents
Planning a Location for your Hot Tub Safety Precautions Controls Featured Operations Fill and Start-up Instructions Cleaning and Maintenance Spa Maintenance Troubleshooting Procedures Electrical Location in Concrete Slab Limited Warranty Electrical Hook Up Owner’s Record 770-381-2022 Fax: 770-925-1900 www.ALPS-spas.com ALPS Spas Ciara XLS...
Page 2: Planning A Location For Your Hot Tub
PLANNING A LOCATION FOR YOUR HOT TUB SAFETY FIRST: Do not place the hot tub within 10 feet (3m) of overhead power lines. *Make sure that your hot tub is positioned so access to the equipment compartment and side panels will not be blocked. Be certain your installation will meet all city and local safety codes and requirements.
Page 3: Safety Precautions
SAFETY PRECAUTIONS 1. Read, keep, and make these instructions available! 2. Children should be CLOSELY supervised at all times. 3. RISK OF CHILD DROWNING! Extreme caution must be exercised to prevent unauthorized access by children. To avoid accidents, ensure that children cannot use hot tub unless they are supervised at all times.
Page 4: Controls
CONTROLS NEW EL/GL 2000 BALBOA CONTROL Quick Reference Card Initial Start-up: conﬁ guration numbers). This priming mode will last up to four minutes and then begin to preset ﬁ lter cycles (--F) for two minutes. Once the diagnostics are complete the control will display the current temperature and begin to heat in the standard mode.
Page 5: Diagnostic Messages
CONTROLS Preset ﬁ lter Cycles: Your spa is programmed from the factory to ﬁ lter twice a day for two hours each time. During this time pump one will come on in low speed automatically. The spa is fully operational at this time and safe to use. If for any reason you would like to change the ﬁ...
Page 6: Hydrotherapy Jets
FEATURE OPERATIONS position. Whirlpool jets are not adjustable (when equipped). Ozonators: The ozone generator engages when the spa is in a ﬁ lter cycle. Please note that the ozonator and chemicals work together to kill bacteria. An ozonator cannot totally eliminate the need for chlorine or bromine.
Page 7: Fill Up And Start Instructions
FILL UP AND START INSTRUCTIONS FILLING THE HOT TUB WITH WATER 1. Clear all the debris from your hot tub. 2. Use a garden hose to ﬁ ll your hot tub with water. 3. Fill just underneath the highest pillow or to the mark on the ﬁ lter faceplate. APPLYING POWER Note: All power connections must be installed by a licensed electrician.
Page 8 FILL UP AND START INSTRUCTIONS NOTE: Calcium deposits can also cause a restriction of air through your jets. Using a stain and scale remover regularly will greatly reduce the chance of this occurring. CHLORINE: Granulated chlorine must be used to remove bacteria and other organic matter from the water.
Page 9: Cleaning And Maintenance
CLEANING AND MAINTENANCE You may need to renew the water in your tub every 3-5 months, depending upon the water condition. To prevent damage to the hot tub’s components, turn off power to the spa at the disconnect before draining the hot tub. Do not turn power back on until your spa has been reﬁ...
Page 10: Filter Cartridge Maintenance
SPA MAINTENANCE FILTER CARTRIDGE MAINTENANCE Based on your model you may have 1 or 2 ﬁ lters in your spa. Every few weeks you will want to check the ﬁ lters and clean them. We recommend Cartridge Filter cleaner from AquaEZ®.
Page 11: Troubleshooting Procedures
TROUBLESHOOTING PROCEDURES In the event ALPS’s hot tub is not working the way it should, please ﬁ rst review all the installation and operating instructions in this manual and check the message on the panel display. If you are still not satisﬁ ed it is working properly, please follow the appropriate troubleshooting instructions.
Page 12: Electrical Location In Concrete Slab
ELECTRICAL LOCATION IN CONCRETE SLAB page 12 PS-Spas 4400 Steve Reynolds Blvd. Norcross, Georgia 300 770-381-2022 Fax: 770-925-1900 www.ALPS-spas.com...
Page 13: Warranty Information
Limited Warranty THIS LIMITED WARRANTY IS EXTENDED TO THE ORIGINAL PURCHASER OF A TETON XLS, CIARA XLS, K2 XLS, Tigra XLS OR SWIM SPA MANUFACTURED BY ALPS SPAS AFTER DECEMBER 1 2005, AND INSTALLED IN NORTH AMERICA ALPS SPAS are warranted against defects in the spa shell due to defects in workmanship and/or...
Page 14 WARRANTY INFORMATION PERFORMANCE OF WARRANTY. To obtain service in the event of a defect covered by this Limited Warranty, notify your ALPS Hot Tub dealer as soon as possible and use all reasonable means to protect the spa from further damage. Freezing temperatures require the hot tub to be protected from freeze damage occurring.
Page 15: Electrical Hook Up
ELECTRICAL HOOK UP • From main panel, run 6-2 with ground to outside disconnect. • Run 6-2 with ground from outside disconnect to spa. • ALPS SPAS recommends that a 60 AMP 220 GFCI must be used in disconnect. • Disconnect must be at least 6 ft. from spa! •...
Page 16: Owner's Record
Spa Dimensions Model Width Teton XLS 82 inches 208.3 cm Ciara XLS 84 inches 213.4 cm Tigra XLS 90 inches 228.6 cm ALPS-Spas 4400 Steve Reynolds Blvd. Norcross, Georgia 30093 ALPS Manufacturing Owner’s Record...

This manual is also suitable for:

Teton xls Tigra xls

Alps Spas Ciara XLS Owner's Manual

Quick Links

Table of Contents

Need help?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Alps Spas Ciara XLS

Summary of Contents for Alps Spas Ciara XLS

This manual is also suitable for:

Table of Contents