Sony PlayStation Portable PSP-1004 Instruction Manual page 15

Overseas use
When travelling note any applicable wireless regulations.
Moisture condensation
If the PSP system or UMD™ is brought directly from a cold location to a
®
warm one, moisture may condense on the lens inside the system or on the
UMD™. Should this occur, the system may not operate properly. In this case,
remove the UMD™ and turn off and unplug the system. Do not put the UMD™
back in until the moisture evaporates (this may take several hours). If the
system still does not operate properly, contact the appropriate PSP
service helpline which can be found within every PSP
manual.
UMD™ handling
• Do not touch the opening on the rear of the disc (recorded surface of the disc)
with your fingers.
• Do not allow dust, sand, foreign objects or other types of dirt to get on the
disc.
• If the UMD™ becomes dirty, gently wipe the exterior and recorded surfaces
of the UMD™ using a soft cloth. Do not use solvents or other chemicals.
• Do not use a UMD™ that is cracked or warped or has been repaired. The
UMD™ may break inside the PSP
Cleaning
For safety reasons, unplug the AC Power Cord from the electrical outlet and
remove the Battery Pack from the system before cleaning.
x Cleaning the exterior surface excluding LCD screen
Wipe gently with a soft cloth. Do not use solvents or other chemicals to clean
the exterior of the PSP
x Cleaning the LCD screen
Wipe gently with a soft cloth.
x Cleaning the connectors
• Do not use when the connectors of the system, AC Adaptor or the AC Power
Cord are not clean. Remove the dirt with a dry cloth. If used when dirty, the
flow of electrical current may be obstructed.
• If the Headphones or Remote Control connectors become dirty, this could
cause noise or interruptions in sound. Wipe the connectors with a dry, soft
cloth to keep in a clean condition.
system, leading to injury or malfunction.
®
system.
®
customer
®
format software
®
Precautions
15