Filling The Spa - Comfort Line Products STG-1 Owner's Manual

15. Wrap the fi ve inch wide vinyl power
pack connector cover around all three
connections between the power pack and
the spa.

FILLING THE SPA

1. Ensure the power pack is not plugged in.
2. Remove the protective caps from the
suction and discharge fi ttings inside the
spa. Place the caps in a safe location.
3. Using a garden hose, fi ll the spa to
approximately one inch above the top
of the second air chamber ring. Be
careful not to over fi ll the spa, or the spa
may overfl ow during use. Each average
adult will raise the water level in the spa
approximately two inches, and the turbo
wave blower action will raise water level
an additional three to four inches.
4. Bleed the air from the fi lter tank by
turning the small black knob on the top
of the fi lter tank counterclockwise. Allow
the fi lter tank to bleed for approximately
one minute, or until water drips from
the fi tting. Turn the fi tting clock-wise to
close the bleed valve.
14
Meijer.com
User's Guide
2"
Approx.
Fill Line