Related Manuals for Comfort Line Products STG-1
Summary of Contents for Comfort Line Products STG-1
- Page 1 Meijer.com Owner’s Manual Models STG-1, STG-2, STG-3, and STG-4 Manufactured by: Comfort Line Products, Inc. 2717 N. Tamiami Trail N. Fort Myers, FL 33903 (888) 997-6366 (239) 997-6366 www.comfortlineproducts.com...
-
Page 2: Warnings / Avertissements
Meijer.com User’s Guide WARNINGS / AVERTISSEMENTS WARNING: CHILDREN SHOULD AVERTISSEMENT: NE LAISSEZ PAS NOT USE SPAS OR HOT TUBS LES ENFANTS UTILISER UN SPA OU WITHOUT ADULT SUPERVISION. UNE CUVE THERMALE SANS LA SUPERVISION D’UN ADULTE. WARNING: DO NOT USE AVERTISSEMENT: POUR ÉVITER SPAS OR HOT TUBS UNLESS QUE LES CHEVEUX OU UNE PARTIE... - Page 3 Meijer.com Comfort Line Products WARNINGS / AVERTISSEMENTS WARNING: PREGNANT AVERTISSEMENT: LES FEMMES OR POSSIBLY PREGNANT ENCEINTES, QUE LEUR GROSSESSE WOMEN SHOULD CONSULT A SOIT CONFIRMÉE OU NON, PHYSICIAN BEFORE USING A SPA DEVRAIENT CONSULTER UN OR HOT TUB. MÉDECIN AVANT D’UTILISER UN SPA OU UNE CUVE THERMALE.
-
Page 4: Important Safety Instructions
Meijer.com User’s Guide IMPORTANT SAFETY INSTRUCTIONS Th e following instructions are required to be printed by Underwriters Laboratory (U.L.) as well as ETL Testing Laboratories, Inc. as a condition of their listing of this product. Th ey contain important safety information, and we strongly encourage you to read and apply them. - Page 5 Meijer.com Comfort Line Products B. Do not bury cord. C. Connect to a grounded, grounding type receptacle only. 5A. WARNING - For 120 volt versions: Th is appliance is provided with a ground- fault circuit interrupter (located near the end of the power supply). With the unit operating, push the test button.
- Page 6 Meijer.com User’s Guide B. Since excessive water temperatures have a high potential for causing fetal damage during the early months of pregnancy, pregnant or possible pregnant women should limit spa or hot water temperatures to 100°F (38°C). C. Before entering a spa or hot tub, the user should measure the water temperature with an accurate thermometer, since the tolerance of water temperature-regulating devices varies.
-
Page 7: Additional Warnings
Meijer.com Comfort Line Products ADDITIONAL WARNINGS 1. Never use an extension cord to connect the Power Pack to a power source. Th e cord could cause a voltage drop which may cause damage to the control and pump motor. 2. Always operate Power Pack with the cord mounted GFCI in place and functional on 120 volt units. -
Page 8: Site Preparation
Meijer.com User’s Guide INSTALLATION SITE PREPARATION 1. Structure: Your spa should always be installed on a structurally sound, relatively smooth, and level surface. 2. Electrical: Your spa should be connected to a grounded outlet within eight feet of the spa. For 120 V units, there should be easy access to the plug for periodic testing of the cord mounted GFCI. -
Page 9: Outdoor Installation
Meijer.com Comfort Line Products OUTDOOR INSTALLATION Your spa may be installed on any level, smooth surface that is strong enough to support the fi lled unit. Observe the following considerations when deciding where to place your spa: 1. Make sure there are no sharp objects under the spa. -
Page 10: Package Contents
Meijer.com User’s Guide PACKAGE CONTENTS Refer to the following picture and product checklist to verify that all parts of the spa have been received and are undamaged. Report and missing or damaged parts immediately. 1. Power Pack 6. Spa Infl ation Hose 2. - Page 11 Meijer.com Comfort Line Products ASSEMBLY 1. Unfold the spa liner to lay fl at. 2. Connect the infl ation hose to the blower exhaust fi tting on the top of the power pack. The key lock pin must be inserted into the adapter of the inflation hose fitting when inflating the spa.
- Page 12 Meijer.com User’s Guide 6. When installing the caps on the infl ation fi ttings, make sure the sealing fl aps on the fi ttings are not pulled out through the infl ation fi ttings. Th is will prevent the fl aps from sealing properly, and may damage the infl...
- Page 13 Meijer.com Comfort Line Products 10. Line up the water connections on the back of the power pack with the fi ttings on the side of the spa. 11. Remove the two labels from the bottom, large fi tting of the spa. Make sure the o- ring inside the fi...
-
Page 14: Filling The Spa
Meijer.com User’s Guide 15. Wrap the fi ve inch wide vinyl power pack connector cover around all three connections between the power pack and the spa. FILLING THE SPA 1. Ensure the power pack is not plugged in. 2. Remove the protective caps from the Approx. - Page 15 Meijer.com Comfort Line Products Plug the spa into a properly grounded electrical outlet. 5. Plug the power pack into the electrical outlet. Th e water pump will turn on and begin pumping water. Water should fl ow from the small return nozzle on the bottom inside wall of the spa behind the power pack.
- Page 16 Meijer.com User’s Guide 8. Connect the eight clips to secure the cover in place. Th e clips may be locked using the small keys provided in the patch kit. Unlocked Locked...
-
Page 17: Operation
Meijer.com Comfort Line Products OPERATION • Test the GFCI before each use. (Refer to the instructions provided in the Maintenance section of this manual.) • Plug into properly grounded receptacle. • Do not use extension cords. Temperature Control 1. During normal operation, the control display on the top of the power pack displays the current water temperature. -
Page 18: Turbo Operation
Meijer.com User’s Guide Turbo Operation To turn the turbo wave pump on or off , push the on/off button. Look to see if the spa blows bubbles uniformly all the way around the spa. If action seems to fade as bubbles circle the spa and are weak on one side, then the lower air chamber is over-infl... -
Page 19: Maintenance
Meijer.com Comfort Line Products MAINTENANCE Vinyl Care - Interior 1. While the spa is empty, clean the spa interior with a mild soap solution to remove any soil or stains on the vinyl. Rinse thoroughly before refi lling the spa. Do not use cleaning aids such as steel wool, metal brushes, or abrasive cleansers such as Comet or Ajax. -
Page 20: Adding Chemicals
Meijer.com User’s Guide Avoid punching too many holes in the bromine feeder, as this could cause over bromination. This could bleach the vinyl, and will void your warranty. If the bromine level in the spa reaches 5 ppm or higher, remove the bromine feeder from the spa until the bromine level drops to the correct 2-3 ppm range. -
Page 21: Cleaning The Filter
Meijer.com Comfort Line Products Cleaning the Filter 1. Unplug the power pack from the electrical outlet. 2. Using the three caps provided, cap the suction and discharge fi ttings on the inside of the spa. 3. Open the air bleed fi tting on the top of the fi... -
Page 22: Draining The Spa
Meijer.com User’s Guide Winterizing and Vacationing If you are taking a vacation or leaving your spa unused for more than a week, you should take a few simple precautions. Leave the spa covered with the plastic clips locked. Leave the turbo wave pump off and set the temperature set point low. - Page 23 Meijer.com Comfort Line Products GFCI (120 volt units only) Th e GFCI, or Ground Fault Circuit Interrupt, fi tting on the power pack electrical cord should be tested monthly. Th ere are no user serviceable parts inside the GFCI. Do not open the GFCI as this will void your warranty.
-
Page 24: Service And Troubleshooting
Meijer.com User’s Guide SERVICE AND TROUBLESHOOTING Your spa was designed to minimize service requirements. If you encounter problems with your spa carefully go through the following steps. Air Pump Blower 1. Turbo wave pump will not turn on: A. Make sure the power pack is plugged into the electrical outlet, and that there is power to the outlet. - Page 25 Meijer.com Comfort Line Products No Heat 1. Dirty fi lter: Clean the fi lter per the instructions provided in the Maintenance section of this manual. If the fi lter is more than two months old, replace it. After cleaning or replacing the fi lter, cover the spa, turn the temperature set point all the way up, and leave the spa for 24 hours.
- Page 26 Meijer.com User’s Guide Leaks 1. Th e two small connections between the power pack and the spa are leaking: Ensure the garden hose style washer inside each of these fi ttings is still in place and undamaged. If the washers are in place and the connection is still leaking, there may be a small piece of plastic behind the hose washer.
-
Page 27: Specifications
Meijer.com Comfort Line Products SPECIFICATIONS Model STG-1 120 VAC Round Model STG-2 240 VAC Round Capacity : Seating: 1-4 adults Water: 250 gallons Outside Dimensions : 82 inches Inside Dimensions : 58 inches Height : 28 inches Number of Jets : 1 return jet Over 100 air jets Power Pack : 1.3 HP turbo blower... - Page 28 Meijer.com User’s Guide SPECIFICATIONS Model STG-3 120 VAC Octagon Model STG-4 240 VAC Octagon Capacity : Seating: 1-4 adults Water: 250 gallons Outside Dimensions : 82 inches Inside Dimensions : 58 inches Height : 28 inches Number of Jets : 1 return jet Over 100 air jets Power Pack : 1.3 HP turbo blower Fractional HP circulating pump...
- Page 29 Th is warranty gives you specifi c legal rights, & you also have other rights that vary from state to state. Specifi cations subject to change without notice. For service call: 1-888-997-6366 Manufactured by: Comfort Line Products, Inc. 2717 N. Tamiami Trail N. Fort Myers, FL 33903...
- Page 30 Meijer.com User’s Guide OWNER’S RECORD Date Purchased _________________________________________ Purchased From ________________________________________ Sales / Rep. / Contact ____________________________________ Address _______________________________________________ Telephone _____________________________________________ Serial # _______________________________________________ Model # ______________________________________________...