Panasonic Viera TC-P42X60H Owner's Manual page 37

Operations
Preparations
VIERA Link connection
●
Set up the connected equipment. Read the
●
manual of the equipment.
Set [VIERA Link] to [On] in the Setup Menu.
●
Set up the TV.
●
After connection, turn the equipment on and
then switch the TV on.
Select the input mode from HDMI1 or HDMI2
(p. 11), and make sure that an image is
displayed correctly.
This setup should be done each time when the
following conditions occur:
for the fi rst time
•
when adding or reconnecting equipment
•
when changing setup
•
Easy playback
Automatic input switching - When the connected
equipment is operated, input mode is switched
automatically.
Image or sound may not be available for the
●
fi rst few seconds when input mode is switched.
Power on Link
Set [Power on Link] to [On] in the Setup Menu
to use this function
When the connected equipment starts playback
or direct navigator / function menu for the
equipment are activated, the TV is automatically
turned on. (Only when the TV is in Standby
mode.)
Power off Link
Set [Power off Link] to [On] in the Setup Menu
to use this function
When the TV is set to Standby mode, the connected
equipment is also automatically set to Standby.
This function will work even if the TV enters
●
Standby mode automatically by auto power
standby function.
(p. 36)
(p. 24)
(p. 24)
(p. 24)
Standby Power Save
Set [Standby Power Save] to [On] in the Setup
Menu to use this function
The power consumption of the connected
equipment in Standby mode is controlled higher
or lower in synchronisation with the TV on / off
state to reduce the consumption.
When the TV is set to Standby mode, the
connected equipment is automatically set to
Standby and the power consumption of the
connected equipment is automatically minimised.
When the TV is turned on, the connected
equipment is still in Standby mode, but the power
consumption is increased to make startup time fast.
This function is effective if the connected
●
equipment can change the power consumption
in Standby mode and is set to higher
consumption.
This function works when [Power off Link] is set
●
to [On].
Intelligent Auto Standby
Set [Intelligent Auto Standby] to [On] in the
Setup Menu to use this function
When the TV is on, non-watched or non-used
connected equipment goes into Standby mode
automatically to reduce the power consumption.
For example, when the input mode is switched
from HDMI or when [Speaker Selection] is
changed to [TV] (except for watching a disc).
This function may not work properly depending
●
on the connected equipment. If required, set to
[Off].
(p. 24)
(p. 24)
37