General Issues Operation - Panasonic Diga DMR-EZ28 Operating Instructions Manual

General Issues
Operation
Page
Cannot operate the TV or Set • Change the manufacturer code on the remote control. 56
Top Box with the unit's remote
• Select TV or Set Top Box mode on the remote control. 56
control.
The remote control doesn't
• The remote control code is wrong. Change to the correct code. 48
work.
• The batteries are depleted. Replace them with new ones.
5
• Point the remote control at the remote control sensor on the main unit. 5
• Remove obstacles between the remote control and main unit.
-
• Remove dust from the transmission window and the unit's sensor.
-
• Colored glass may obstruct the signal reception/transmission. -
• Don't place the signal sensor in direct sunlight or in areas that may be
-
subject to sun exposure.
• It may be necessary to set the code on the remote control again after 48
changing the batteries.
• It may be necessary to set the manufacturer code again after 56
changing the batteries.
The unit is on but cannot be • Some operations are prohibited by the disc.
-
operated.
• The unit is warm ("U59" appears on the unit's display). Wait until "U59"
-
disappears.
• One of the unit's safety devices may have been activated.
-
Reset the unit as follows:
Press [POWER 6/1] on the main unit to switch to off.
If the unit doesn't switch to off, reset the unit (-+ 70, 'To restore the
unit if it freezes").
"U88" is displayed and the disc • The unit is carrying out the recovery process. Do the following to eject the disc: -
cannot be ejected. (1) Press [POWER 6/1] on the main unit to switch to off.
If the unit doesn't switch to off, reset the unit (-+ 70, "To restore the
unit if it freezes").
(2) While the unit is off, press and hold [II] and [CH 1\) on the main unit
at the same time for about 5 seconds. (Ejection may take extra time
depending on discs.) The disc may be defective. Try another disc.
Cannot eject a disc.
• The unit is recording. -
• The unit may have a problem. Eject the disc as in (2) above. -
Startup is slow.
• Startup takes time in the following situations:
-
- A disc other than a DVD-RAM is inserted.
- The clock is not set.
- Immediately after a power failure or the AC power supply cord is
connected.
- When the unit is connected with an HDMI cable.
A password screen appears • If the unit starts receiving a broadcast with the set rating information, 47
and you are unable to view or a password screen appears and you will be unable to view or record.
record.
Enter your password to continue.
Time is incorrect after using • Try again. If the time is still incorrect, set the clock manually. 49
Auto Clock Setting.
Cannot set "24p Output for
• Only when the unit is connected to the HDMI terminal of a TV 55
DVD-Video".
supporting 24p, you can set "24p Output for DVD-Video". In some
cases where the unit is connected to a TV via an amplifier/receiver
through the HDMI terminals, you may not be able to set it. In this
case, connect the unit to a TV through the HDMI terminal and
connect it to the amplifier/receiver through any terminal other than
HDM!.
ROT9046