Table of Contents
Advertisement
Wireless Remote Controls: Programming
Wireless In-Dash & Hand-Held Remote Control Programming:
The camera is controlled with a programmable remote with different chan-
nels . This feature allows you freedom to change the channel selection, and
the receiver relearns the new selection .
Programming the transmitter
This camera has been pre-programmed at the factory, and is not necessary
to re-program the transmitter, unless you experience outside interference .
Important Note: Disconnect power by removing fuse or disconnecting vehicle
battery .
1 . Remove battery cover from remote control .
2 . Set the 7 dip switches to a selection of your choice . There are 3 positions
on each; positive, negative and neutral . Use a small screwdriver and se-
lect a position for each dip switch . Please note that the orientation of the
+/- switch positions may vary among different models of wireless remote
controls .
3 . Make sure batteries are installed correctly and have adequate charge .
4 . Replace battery cover .
5 . Depress the on/off button and hold it down . Red LED will light .
6 . While holding the on/off button down, reinstall the power .
7 . Keep your finger on the on/off button for 5-6 seconds, and then release .
The camera should now be programmed .
10
Advertisement
Table of Contents
