HELICOPTER LAYOUT Stabilizer Main Rotor Connecting Shaft Blade Main Rotor Blade Tail Rotor ON/OFF Switch Landing Skid Charging Helicopter Wire ON/OFF and charging Socket male located on the left hand side of chopper. AC Adaptor Socket CONTROLLER LAYOUT Power Indicator Direction Throttle Joystick...
ongratulations on your new EXRC purchase! EXRC pilots experience ight and excellence in the look and feel of our products while commanding the skies. Now that you are an honorary EXRC pilot, we recommend reading through this manual thoroughly before ight tips, safety precautions, and care instructions to keep your EXRC helicopter in tip-top...
Charging the Helicopter: Switch 1. Turn the helicopter power OFF. 2. Disable the connection between the Charging Wire (male) and the Helicopter Socket (female). 3. Plug the Charging Wire (male) into the AC Socket (female). 4. Plug the AC Adaptor into the wall. Switch AC Wall Unit 5.
Page 5
RIGHT joystick - Keep the helicopter at a steady height. Press the RIGHT joy- stick to the left to turn the helicopter counterclockwise. Press the RIGHT joystick to the RIGHT to turn the helicopter clockwise. Adjust the trim to avoid spins. Move the Right joystick up or down to move the helicopter forward or backward.
FLIGHT CONDITIONS ight conditions are optimal before launch. • This chopper was built for outdoor terrain only with minimal wind conditions. Heavy wind conditions can be to strong for this chopper resulting in a“Mayday” situation. ight to be at least 10 x 15 x 10 ft. CONTROL TIPS •...
TROUBLESHOOTING For best results, do not use batteries with power strip indicators (such as Duracell Ultra Power batteries and Duracell Ultra Advanced with Powercheck). Should you wish to continue to use these batteries, please be sure that all power strips are facing forward when placed in the battery compartment. In some cases, it may also help to remove, reinsert and push the batteries forward ensuring proper contacts are being made.
Need help?
Do you have a question about the War Bird II and is the answer not in the manual?
Questions and answers