eb brands Glow Copter XC9893 User Manual

Remote control helicopter

Advertisement

Quick Links

XC9893
XC9893IS01JCPRA.indd 1
XC9893IS01JCPRA.indd 1
Glow Copter
Remote Control Helicopter

User Guide

SAVE THESE INSTRUCTIONS.
READ COMPLETE INSTRUCTIONS BEFORE USE.
5 x 7
Original: 6/9/12;
XC9893IS01JCPRA
Revision & RA 7/10/12
© 2012 EB Brands
7/12/12 9:18 AM
7/12/12 9:18 AM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Glow Copter XC9893 and is the answer not in the manual?

Questions and answers

Summary of Contents for eb brands Glow Copter XC9893

  • Page 1: User Guide

    Glow Copter Remote Control Helicopter User Guide SAVE THESE INSTRUCTIONS. READ COMPLETE INSTRUCTIONS BEFORE USE. XC9893 © 2012 EB Brands XC9893IS01JCPRA.indd 1 XC9893IS01JCPRA.indd 1 7/12/12 9:18 AM 7/12/12 9:18 AM XC9893IS01JCPRA 5 x 7 Original: 6/9/12; Revision & RA 7/10/12...
  • Page 2: Controller Layout

    Congratulations on your new EXRC purchase! EXRC pilots experience superior remote control fl ight and excellence in the look and feel of our products while commanding the skies. Now that you are a honorary EXRC pilot, we recommend reading through this manual thoroughly before attempting your fi rst fl ight.
  • Page 3: Battery Installation And Charging

    ACTIVATING GLOW IN THE DARK FEATURE Energize the Glow Copter’s glow in the dark body by using a bright light source (e.g. next to the window on a sunny day or under a table lamp) for 10 minutes. Please be sure that the helicopter is turned off. Caution: Do not leave the Glow Copter unattended under direct sunlight for a prolonged period of time.
  • Page 4: Flying Your Helicopter

    FLYING YOUR HELICOPTER Band Selector GETTING STARTED Band Selection 1. Select the frequency band on the controller. (A, B or C) 2. Move the chopper’s switch to the ON position. The helicopter will light up, indicating it is on. 3. Carefully hold the chopper in one hand, be sure the blades are clear of any obstacles.
  • Page 5: Flight Conditions

    TRIMMING HELICOPTER/DIRECTION CONTROL Virtually no trimming is required for the Glow Copter. However, if the helicopter rotates during fl ight, use the Rudder Trim Knob on the top right side to adjust. 1. When the helicopter is spinning clockwise, turn the Rudder Trim Knob counterclockwise to adjust.
  • Page 6: Safety Tips

    SAFETY TIPS • Read through the entire instruction manual, before attempting to pilot your helicopter. • This product is intended for indoor use, and works best indoors. We do not recommend using the product outdoors. • Never attempt to fl y your helicopter in a cluttered space. This helicopter was intended for obstacle free wide area spaces.
  • Page 7: Care And Handling

    TROUBLESHOOTING (continued) Problem Cause Correction Avoid all other remote controlled devices running Loss of Control Interference of another on the same channel. remote controlled device Interference by other Change environment to better suited conditions. conditions such as lighting. Helicopter Spinning out Incorrect trim Adjust the trim as shown above to fi nd the proper adjustment.
  • Page 8 Product replacement policy only covers normal wear and tear when the product is used as directed. Normal wear and tear does not include damage caused by crashes, collisions, or any use other than as directed. Distributed by EB Brands, Hazleton, PA 18202 www.goexrc.com service@EBExcalibur.com...

Table of Contents