Break-In Proceedures; Maintenance - Lawn Solutions TA21 Owner's Manual

BREAK-IN PROCEEDURES

1. After the first 10-20
hours check the drive
chains for proper
tension. New chains
will stretch in the
first few hours of
use. If you can hear
them flopping around
inside the chain
covers they are too
loose.
2. After the first 25-50
hours check the
drive belt to the
hydrostatic pump for
tension. New belts
will stretch during
the first few hours of
use.
TA21 Owner's Manual
Lawn Solutions Commercial Products, Inc.
502-968-3188

MAINTENANCE

1. Cleaning – tip
unit back for
cleaning. NOTE:
tipping the unit
forward can flood
the engine with
fuel and oil.
2. Before each days use:
a. Check the engine air filter
b. Lubricate the chains and 2
grease fittings on the floating
tines (center tines).
c. Inspect the chain tension when
lubricating. Chains should not
flop around during use.
3. Every 100 hours
a. Replace the engine air filter
b. Change the engine oil
c. Check and adjust chain tension
if needed.
Page | 7