Table of Contents
Advertisement
consisting of the existing ANSI/IEEE standard and the guidelines published
by the National Council of Radiation Protection and Measurements (NCRP).
Body-Worn Operation
To maintain compliance with FCC RF exposure guidelines, if you wear a
handset on your body, use an approved carrying case, holster or other
body-worn accessory. If you do not use a body-worn accessory, ensure the
antenna is at least
(
7/16 inch
1.5 centimeters
transmitting. Use of non-approved accessories may violate FCC RF
exposure guidelines.
For more information about RF exposure, visit the FCC website at
.
www.fcc.gov
Specific Absorption Rates (SAR) for Wireless Phones
The SAR value corresponds to the relative amount of RF energy absorbed
into the head of a user of a wireless handset.
The SAR value of a phone is the result of an extensive testing, measuring
and calculation process. It does not represent how much RF the phone
emits. All phone models are tested at their highest value in strict laboratory
settings. But when in operation, the SAR of a phone can be substantially
less than the level reported to the FCC. This is because of a variety of
factors including its proximity to a base station antenna, phone design and
other factors. What is important to remember is that each phone meets
strict federal guidelines. Variations in SARs do not represent a variation in
safety.
All phones must meet the federal standard, which incorporates a
substantial margin of safety. As stated above, variations in SAR values
between different model phones do not mean variations in safety. SAR
) from your body when
values at or below the federal standard of 1.6 W/kg are considered safe for
use by the public.
The highest reported SAR values of the PLS-m350 are:
:
Cellular CDMA mode (Part 22)
Head: 0.68 W/kg; Body-worn: 1.15 W/kg
PCS mode (Part 24)
:
Head: 1.08 W/kg; Body-worn: 1.31 W/kg
FCC Radio Frequency Emission
This phone meets the FCC Radio Frequency Emission Guidelines.
FCC ID number: A3LSPHM350.
More information on the phone's SAR can be found from the following FCC
website:
http://www.fcc.gov/oet/ea/
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
4A. Important Safety Information
.
137
Advertisement
Table of Contents
