Fujitsu ESPRIMO P15 Series Operating Manual page 43

Installing an accessible 5
► Open the casing (see
Drive, Accessible drive,
► If a slide-in module is fitted, remove this first. To do this, proceed in the same way as when
removing a drive (see
Do not dispose of the empty slide-in module. For cooling, protection against
fire, and in order to comply with EMC regulations, you must refit the empty
slide-in module if you remove the drive again later.
► Take the new drive out of its packaging.
► Make the desired settings on the new drive (if necessary, to the settings of
drives already installed as well (Master/Slave)).
► Slide the drive into the casing (1). Make sure that the screw holes are aligned.
► Fasten the drive in place with the screws (2).
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Close the casing (see
It may be necessary to modify the entry for the drive in the BIOS Setup.
Fujitsu Technology Solutions
/ inch drive (e.g. DVD drive)
1
4
"Opening the casing", Page
"Removing an accessible 5
"Closing the casing", Page
32).
/ inch drive (e.g. DVD drive)", Page
1
4
2
33).
System expansions
38).
2
1
39