Specifications; Troubleshooting - Sharp IG-A10A Operation Manual

SPECIFICATIONS

Model
Power supply
Power consumption (W)
Operating noise level (dBA)
Airflow volume (m 3 /hour)
Applicable floor surface area (m 2 )*
Power cord (m)
Outer dimensions (mm)
Weight (kg)
*The target floor surface area for which an emitted airborne ion density of about 25,000 ions/cm
be measured at a point near the center of the room (at a height of about 1.2 m from the floor), during
operation at the HIGH mode when the main unit is placed near a wall.
• The number of ions will vary according to the room conditions and the main unit operation mode.

TROUBLESHOOTING

Before calling for service, please review the TROUBLESHOOTING chart below,since the problem may
not be Plasmacluster Ion Generator malfunctions.
Problem
The Plasmacluster Ion Generator
does not work.
flashing (blue)
flashing (blue)
The discharged air has odor.
A clicking or ticking sound comes
from the unit while operating the
Plasmacluster Ion Generator.
(High)
(High)
(High)
Make sure to put in the plug.
Approx. 2 years and 2 months (approx. 19,000
hours) has been passed.
Replace with a new Plasmacluster Ion Generating
flashing faster
Unit. See page E-6,7.
(red)
If all lights keep flashing, replace with new
Plasmacluster Ion Generating Unit. See page E-6,7.
flashing (red)
•
Failure
Unplug and contact the store you purchased or
Sharp Service Center.
flashing (blue)
The Plasmacluster Ion Generator releases a
small trace of ozone which may produce odor.
This is not harmful to health.
Loudness can be changed depending on a room
humidity, but the effectiveness is the same.
Relocate the Plasmacluster Ion Generator if
necessary.
220-240V, 50/60Hz
14.0
44
102
140 160 345 (W
WHAT TO DO
Plasmacluster Ions are not released.
Press the Operation button and restart.
Dust may block the filter, clean the filter.
E-8
IG-A10A
(Low)
(Low)
(Low)
10
1.8
D H)
2.5
6.5
34
72
3
can