Remote Start Faults - Viper 5606V Owner's Manual

Note Turbo Timer must be turned on by an authorized Directed
dealer.
Note
For Turbo Timer mode on manual transmission vehicles fol-
low the directions in the Manual Transmission Start (MTS
mode) section with the door open and in step 3 send the
Timer Mode command from the remote control.

Remote Start Faults

For user safety, the system must be properly configured or remote start
will not activate. A Remote Start Fault may be caused by any of sev-
eral configuration issues. If the remote start fails to activate, refer to the
table below for the command type and parking light flashes that will
identify the configuration issue and solution.
Flashes * Possible Fault
5 Brake on
6 Hood open
7 After performing Remote Start
command - MTS not enabled
After performing Timer Start or
Smart Start command
8 Toggle Switch off
None Alarm is triggered
* Refers to the number of parking light flashes.
24
Solution
Release foot brake
Close hood
Enable MTS mode
Check all Solutions
Turn switch on
Disarm or reset alarm
© 2013 Directed. All rights reserved.