IBM 10K3799 User Manual page 26

8x slimline dvd-rom drive
Table of Contents

Advertisement

When the DVD-ROM drive is properly installed, a DVD-ROM or CD-ROM
icon is displayed in the My Computer window. Double-click My Computer.
If a CD-ROM icon is not present in the window that opens, verify that the
drive has been properly installed. Verify that the configuration jumper is set
properly. Restart your computer. If a drive icon is still not found, continue
with the following steps.
1. Click Start, then click Settings, and then click Control Panel.
2. Click System.
3. Click the Device Manager tab.
4. Double-click View Devices by Type.
5. Select Hard Disk Controllers from the list displayed in the Device
Manager window. Verify that there are no conflicts with the controller.
The device status indicates whether the controller is working properly.
6. Select CD-ROM from the list that is displayed in the Device Manager
window. Verify that a CD-ROM device is present in the list and that no
conflicts exist. The device status indicates whether the device is working
properly.
7. Click OK.
8. Close all windows and restart the computer.
If the device icon is still not present, check cable connections and
device-jumper settings, and resolve any conflicts that might exist.
v The DVD-ROM drive is not recognized by the operating system, or the
drive performs erratically.
Some computers have Compatible and High Performance modes for mass
storage devices. Normally, the DVD-ROM drive functions better under the
High Performance mode. However, if your drive is not functioning properly
in that mode, you might need to use the Compatible mode.
Use the following procedure to check the configuration-setup information for
your computer.
1. Access your configuration utility program. (For IBM systems, press F1 at
time of system start-up.
2. Select Devices.
3. Scroll down to the Mass Storage Devices section.
Refer to the documentation that comes with your computer for additional
details on selecting IDE performance modes.
v The computer does not recognize the DVD-ROM drive after the device
drivers are loaded.
Check for incompatibilities among the DVD-ROM device driver and other
device drivers or other hardware in your computer. Create a system diskette
with minimum CONFIG.SYS and AUTOEXEC.BAT system files.
B-2
8X Slimline DVD-ROM Drive: User's Guide

Advertisement

Table of Contents
loading

Table of Contents