Im Por Tant In For Ma Tion; Re Quired In Stal La Tion Tools; Sys Tem Com Po Nents - Clifford ACE 7500 Installation Manual

Mobile security / convenience system with built-in remote engine starter

Hide thumbs Also See for ACE 7500:

Complete owner's manual (13 pages)

Table Of Contents

Table of Contents

1. DO NOT dis con nect the bat tery ca bles! Make bat tery con nec tions by re mov ing the lug

nuts from the bat tery clamps with out de tach ing the clamp it self.

2. Turn off the in te rior lights or re move the dome light fuse bef ore start ing the in stal la tion;

oth er wise, leav ing the door(s) open dur ing in stal la tion will drain the bat tery.

3. Use a volt me ter. DO NOT USE A TEST LIGHT! Test lights have a cur rent drain that

will dam age the ve hi cle's on board com puter, and if you probe the wrong wire, could

de ploy the ve hi cle's air bag(s).

4. Make all con nec tions with sol der and tape. DO NOT use bite- type con nec tors.

5. Route the sys tem's ground and power wires di rectly to the ve hi cle bat tery.

6. Keep ex ten sion as short as pos si ble. Use same- gauge wire for short ex ten sions, larger gauge

for longer ex ten sions. DO NOT USE SPEAKER WIRE!

7. Dis cuss place ment of the LED, valet switch, win dow de cals, etc. with the ve hi cle owner

prior to in stal la tion.

8. DO NOT mount com po nents nor route wires near hot or mov ing ve hi cle parts. Clif ford

com po nents must not im pede ve hi cle serv ic ing or op era tion.

9. DO NOT mount any Clif ford sen sor in the en gine com part ment.

10. Fol low the sys tem's Se quence of In stal la tion to en sure proper in stal la tion and test ing.

11.Place the own er's man ual in the glove box.

Note: Clif ford Elec tron ics' web site for Author ized Clif ford Deal ers has

de tailed de scrip tions of wire col ors and lo ca tions for most for eign and

do mes tic ve hi cles. In stal la tion dia grams and pro gram ming pro ce dures for

older Clif ford prod ucts are also avail able. See www.clif ford deal ers.com

(USER NAME=roadshop PASSWORD=cliffg4) for as sis tance 24- hours per day.

Voltmeter (set to "DC Volt")

Wire crimper

Wire stripper

Electric drill and bits

Phillips screwdriver

Crescent wrench

Vinyl tubing

Rubber grommet

Convoluted tubing

Solder gun and solder

The ACE 7500 kit contains the following components:

One Prewired 24-pin Connector Harness

One Prewired 12-pin Connector Harness

One ACE 7500 Control Unit

One PlainView 2 Coded Valet Switch

Two Remote Transmitters

Remotely Adjustable Dual-Zone Piezo Sensor

One Glass Tampering Sensor