JBL OnBeat Venue LT Quick Setup Manual

JBL OnBeat

Quick Setup Guide

WeLcOme

Thank you for purchasing the JBL OnBeat

guide will show you how to connect and set up your dock.

cOnnectIOnS

1. If you are going to use your OnBeat Venue LT with another audio source, plug one end of

a 3.5mm (1/8") stereo cable (not supplied) into the OnBeat Venue LT's Aux In connector,

and plug the other end into the audio source's audio out or headphone out connector.

2. Plug the OnBeat Venue LT's power supply into the Power connector on the unit and into

a working AC power outlet. The OnBeat Venue LT will automatically turn on and go into

the Bluetooth pairing mode (the Bluetooth LED will be flashing blue).

VenUe Lt

™

Venue LT speaker dock. This quick setup

™

Power

Aux

Connector

Input

Page 1 1. If you are going to use your OnBeat Venue LT with another audio source, plug one end of a 3.5mm (1/8") stereo cable (not supplied) into the OnBeat Venue LT’s Aux In connector, and plug the other end into the audio source’s audio out or headphone out connector.
Page 2: Controls And Indicators
PLACEMENT Place OnBeat Venue LT on a shelf or table with the rear of its enclosure is at least 3" (76mm) away from a wall or other surface to allow the bass ports to operate properly. CONTROLS AND INDICATORS Dock Input...
Page 3: Bluetooth Wireless Streaming
When the OnBeat Venue LT is in the standby mode it will automatically turn on when it detects audio playing from a Bluetooth-connected device or from a docked device. When the OnBeat Venue LT is on, it will automatically enter the standby mode after 10 minutes of inactivity (no audio input and no user-control operation).
Page 4 8500 Balboa Boulevard, Northridge, CA 91329 USA © 2012 HARMAN International Industries, Incorporated. All rights reserved. JBL is a trademark of HARMAN International Industries, Incorporated, registered in the United States and/or other countries. JBL OnBeat is a trademark of HARMAN International Industries, Incorporated.