Makita HM1500B Instruction Manual page 5

Installing or removing bull point or other bits (cold chisel, etc.)
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before installing or removing
the bit.
This tool accepts bits either with or without a collar on i t s shank.
Bit with collar
/ h
a
W
I I
Bit without collar
To
install the bit, follow either procedure
( 1 )
or (2) described below.
(1
)
For bits with
a
collar:
Pivot the tool retainer back and slightly downward. Insert the bit into the tool holder
as
far as it will go.
To
securely retain the bit, return the tool retainer to
i t s
original
position.
I
I
When the bit is
inserted.
When the b i t
is
retained.
Fig. (1
CAUTION
:
Always assure that the bit is securely retained by attempting to pull the bit out of
the
tool
holder after completing the above procedure.
5