Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for XtreamAIR PX01-I36
Summary of Contents for XtreamAIR PX01-I36
- Page 1 INSTALLATION GUIDE & USER’S MANUAL PRO-X SERIES Island Mount Range Hood PX01-I36 & PX01-I42 PX04-I36 & PX04-I42 PX06-I36 & PX06-I42 PX05-I36 & PX05-I42 IMPORTANT: READ AND SAVE THESE INSTRUCTIONS FOR RESIDENTIAL & INDOOR USE ONLY www.XtremeAirUsa.com PAGE...
-
Page 2: Table Of Contents
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS………………………………………………………..2-3 HEIGHT & CLEARANCE REQUIREMENT………………………………………………..……4 VENTING REQUIREMENT……………………………………………………………….…….…4 VENTING METHODS………………………………………………………………………………4 ELECTRICAL REQUIREMENT……………………………………………………………….….5 TOOL NEEDED……………………………………………………………………………………..5 PART SUPPLIED………………………………………………………………………….……….5 RANGE HOOD DIMENSIONS………………………………………………………………...….6 INSTALLATION………………………………………………………………………………..…..6-9 RANGE HOOD OPERATION……………………………………………………………..…...…9-10 SPECIFICATION………………………………………………………………….…….………….10 TROUBLE SHOOTING………………………………………………………………….…..……11 REPLACING THE LIGHT BULB……………………………………………….………………...11 USE & CARE………………………………………………………………….………….……...…12 IMPORTANT SAFETY INSTRUCTIONS : The Important Safety Instructions and warnings in this manual are not meant to cover all MPORTANT OTICE... -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS- continue WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: *Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer PRODUCT: Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty. -
Page 4: Venting Requirement
HEIGHT VENTING REQUIREMENT &CLEARANCE IMPORTANT: NEVER exhaust air or terminate duct work into spaces between • walls, crawl spaces, ceiling, attics or garages. All exhaust must be ducted to the outside. Hood mounted too low could result in heat damage and fire hazard; •... -
Page 5: Electrical Requirement
ELECTRICAL REQUIREMENTS: IMPORTANT: Observe all governing building codes and city ordinances. ■ A 120 volt, 60 Hz., AC only, 15-amp, fused electrical circuit is required. It is the customer’s responsibility: To contact a qualified electrical installer. • To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/ •... -
Page 6: Installation
HOOD DIMENSION PX01-I36, PX01-I42 PX05-I36, PX05-I42 INSTALLATION PX04-I36, PX04-I42, PX06-I36, PX06-I42 Step 1: Mark “Ceiling Bracket” on the ceiling. 1. Put a thick, protective covering over counter top, cook top or range to protect from damage or dirt. 2. Find and mark the center point directly above your cook top 3. - Page 7 STEP 3: Install support brackets 1. Attach multiple hoses brackets vertically outside the 4 corner of the ceiling bracket as show in Figure 3A. Figure 3A 2. Attach brackets vertically inside of the 4 multiple holes brackets installed in previous step (3A). Note: make sure extend the brackets to the appropriate length.
- Page 8 To avoid scratching the chimney, extend the inner upper chimney slowly and carefully to the chimney-mounting bracket. STEP 7: Install oil tunnel & baffle filters 1. PX01-I36 & PX01-I42 A. DROP OIL TUNNEL: INTO THE INSIDE HOOD BODY SLOT. REFER TO LEFT FIGURE B.
-
Page 9: Range Hood Operation
2. PX05-I36 & PX05-I42 A. DROP 2 OIL TUNNELS: INTO INSIDE HOOD BODY SLOT AT BOTH ENDS. REFER TO LEFT FIGURE B. INSTALL BAFFLE FILTERS; refer to Figure on the left for the following three steps: 1. Angle baffle filter toward side end of hood RANGE HOOD OPERATION 2. - Page 10 A. Activating Normal Blower Function: 00 = blower off • While the range hood is off, F1 = quiet speed Touch (+) to start from lowest speed, F1 F2 = low speed Touch (-) to start from Highest speed, F4 F3 = medium speed Touch (+) or (-) again to change the blower speed as indicated in LCD panel F4 = high speed...
-
Page 11: Specification
1. (1) To power ON/OFF, and to activate power-off delay timer. 2. (2) To decrease blower (motor) speed, decrease timer value, and enter timer mode. 3. (7) To increase blower (motor) speed, increase timer value, and cumulative timer reset. 4. (3) Blower (motor) is running light indicator 5. -
Page 12: Trouble Shooting
Noise Level Approximately 0.7 Sone(35dB) to 6.5 Sone (67dB) (Lowest to Highest Speed) Number Of Motors Single Motor Motor Type Single Chamber Ultra Quiet Fan Type Squirrel Cage Filtration Type Heavy Duty Stainless Steel Baffle Filter Illumination LED light, 2W Maximum Venting Size Top 8 inches Round Interference Protection... -
Page 13: Use & Care
USE & CARE INFORMATION: Operations: Read and understand all instructions and warnings in this manual before operating the appliance. Save these • instructions for future reference. Always leave safety grills and filters in place. Without these components, operating blowers could catch on to •...