To Cancel Programming; If Programming Is Unsuccessful; To Clear The Memory Of The Remote; The Numeric Codes Corresponding To The Component - Sony STR-DE985 Operating Instructions Manual

See the tables on pages 54 and 55 for
information on the numeric code(s)
corresponding to the component and the
maker of the component (the first digit and
the last two digits of the numetic code
correspond to the category and the maker's
Once the numesic code has been verified,
the indicator slowly flashes twice and the
remate automatically exits the programming
mode.
Press USE MODE during any step. The
rermte automatically exits the programming
mode.
ed button to activate the
function you wani.
0 If the indicator does not light up in step 1, the
batteries are weak. Replace both batteries.
e If the indicator flashes 4 times in quick succession
while entering tbe numeric code, an error has
occurred. Start again from step 1.
m The indicator turns off while a valid button is
pressed.
* In step 2, if several function buttons are pressed,
only the last pressed button is valid.
4 In step 2, if you press TV I/O, only TV VQL +/-,
TV CH +I-, TVNDEO and WIDE buttons are
reprogrammed.
@ In step 3. if a function button is pressed, the new
function is selected and the programming procedure
returns to the beginning of step 3.
a For the numeric codes, oniy the first three numbers
entered are valid.
To clear all programmed ad learned signds,
dc3 the foollowing to reset the remote to factory
settings.
ator flashes 3 times, then goes off.
Use the rmumeric codes in the tables below to
controf non-Sony components and also Sony
components that the remote is normally unable
to comd. Since the remote signal that a
component accepts diBers de-pending on the
model and year of the component, mose &an
one numeric axie may be assigned to a
component. If you fail to progsam yolar semote
using me of the codes, try usirmg other codes.
The numeric codes are based on the latest
information available for each brand. There is a
chance. however, that your compotlent will not
respond to some or all of the codes.
* AU of the functions on this remote may not be
available wher used with your pa.&xlar
component.