Adding And Erasing Channels Manually; Changing Channels; Selecting The Quick Restart - Toshiba 46HM84 Owner's Manual

Adding and erasing channels manually

After you have programmed the channels automatically, you can
manually add or erase specific channels.
To add or erase channels:
1. Select the channel you want to add or erase. If you are adding a
channel, you must select the channel using the Channel Number
buttons.
2. Press MENU, and then press x or • until the SET UP menu
appears.
3. Press y or z to highlight ADD/ERASE, and then press ENTER
to display the pull-down menu.
SET UP
LANGUAGE
CLOCK SET
ANT 1 / 2
TV / CABLE
CH PROGRAM
ADD / ERASE
: S E L E C T ENTER : SET
4. Press y or z to select ADD or ERASE, depending on the
function you want to perform.
5. Repeat steps 1-4 for other channels you want to add or erase.

Changing channels

To change to a specific channel (programmed or unprogrammed):
Press the Channel Number buttons (0–9 and 100).
For channels 100 and higher, press the 100 button, and then the
next two numbers. For example, to select channel 125, press 100,
2, 5.
To change to the next programmed channel:
Press Channel y or z on the TV or remote control.

Selecting the Quick Restart

With the Quick Restart feature set to ON, the TV stays in standby
mode for several minutes after the TV is turned off.
If the TV is turned on from standby mode, the full picture appears
immediately.
1. Press MENU, and then press x or • until the CUSTOM menu
appears.
2. Press y or z to highlight QUICK RESTART, and then press
ENTER.
3. Press y or z to select ON or OFF, and then press ENTER.
CUSTOM
ON T I MER
SLEEP T I MER
CC
FAVOR I TE CH
CH LABEL I NG
V I DEO LABEL
BACKGROUND
QU I CK RESTART
: S E L E C T ENTER : SET
A D D
E R A S E
O N
O F F
Control touchpad on TV front
TV/VIDEO EXIT CHANNEL VOLUME
x •zy
POWER
TV/VIDEO RECALL
INFO
1 2 3
4 5 6
Channel
7 8 9
Number
+10 CHRTN
0
100
ENT
FAV
MENU
MENU
DVDMENU yzx •
FAV
ENTER
TV
CBL/SAT CH VOL
Channel yz
VCR
DVD
POP DIRECT CH MUTE SLEEP
TV/VCR PAUSE STOP PLAY
FREEZE SOURCE SPLIT
REW FF SKIP/SEARCH
CH SCAN SWAP POP CH
REC
LIGHT
Note:
If Quick Restart is set to OFF and you turn off
the TV, it can take up to several seconds for
the picture to appear when you turn on the
TV again.
If Quick Restart is set to ON and you turn off
the TV, the following will occur for a few
minutes:
• The screen (lamp) lights dimly.
• The fans continue to run.
This is a function of the Quick Restart feature
(standby mode) and is not a TV malfunction.
If you do not prefer this, set the Quick Restart
feature to OFF.
When in the Quick Restart OFF mode, if you
continue to switch the TV ON and OFF in a
short time, the useful service life for the lamp
may be shorter than the average useful
service life.
See "Appendix" on page 56.
MENU
MENU
25