Electrical Preparation - Bosch Dishwasher Installation Instructions Manual

B 30"
(762mm)
21"
(533mm)
A
Figure 5
3" - 4"
( 75mm - 100mm)
3/8" - 1/2"
( 8mm - 13mm)
Figure 6

Electrical Preparation

ELECTRICAL PREPARATION
WARNING: ELECTRICAL SHOCK
HAZARD - Working on an energized circuit
could result in serious injury or death. Only
qualified electricians should perform electri-
cal work. Do not attempt any work on the
dishwasher electric supply circuit until you
are certain the circuit is de-energized.
WARNING: FIRE HAZARD - Improper
electrical work can cause fire. Only qualified
electricians should perform electrical work.
Electrical Supply
The customer has the responsibility of ensuring that the
dishwasher electrical installation is in compliance with all
national and local electrical codes and ordinances. The
dishwasher is designed for an electrical supply of 120V, 60
Hz, AC, connected to a dishwasher-dedicated, properly
grounded electrical circuit with a fuse or breaker rated for
15 amps. If the dishwasher is connected with a food
disposer, a 20 amp (and no higher) fuse or circuit breaker
may be used. Electrical supply conductors shall be a
minimum #14 AWG copper wire.
Regardless of where the electrical supply cable enters the
enclosure (following the guidelines on page 8), position the
cable 21" (533mm) from the enclosure's left side, as
shown in Figure 5, letter A. Extend the cable 30" (762mm)
from the enclosure's back, as shown in Figure 5, letter B.
Remove 3" - 4" (75mm - 100mm) of the cable's outer
casing, as shown in Figure 6, letter C, then remove 3/8" -
1/2" (9 - 13mm) of insulation from each conductor, as
shown in Figure 6, letter D.
Dishwasher Electrical Rating
V l o s t
1 2 0
H e r z t A m p e e r s
6 0 1 5
W t a s t
1 4 , 5 0
( m a ) x
5