Specific Safety Rules - Central Pneumatic 97526 Assembly And Operation Instructions Manual

Disconnect the air supply before making any adjustments, changing
18.
accessories, or storing the tool. Such preventive safety measures reduce the
risk of starting the tool accidentally. Always unplug the tool from its air supply
before performing any inspection, maintenance, or cleaning procedures.
Store idle tools out of reach of children and other untrained persons. Tools
19.
are dangerous in the hands of untrained users. Never allow children to come in
contact with this product.
Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained
20.
tools with a sharp cutting edge are less likely to bind and are easier to control. Do
not use a damaged tool. Tag damaged tools "Do not use" until repaired.
Check for misalignment or binding of moving parts, breakage of parts, and any
21.
other condition that may affect the tool's operation. If damaged, have the tool
serviced before using. Many accidents are caused by poorly maintained tools.
1. Tool service must be performed only by qualified repair personnel. Service or
maintenance performed by unqualified personnel could result in a risk of injury.
When servicing, use only identical replacement parts. Follow instructions
2.
in the "Inspection, Maintenance, And Cleaning" section of manual. Use of
unauthorized parts or failure to follow instructions may create a risk of injury.
Maintain labels and nameplates on the Air Nailer. These carry important
1.
information. If unreadable or missing, contact Harbor Freight Tools for a
replacement.
Maintain a safe working environment. Make sure there is adequate surrounding
2.
workspace. Do not use this product in a damp or wet location.
When using this Air Nailer, always maintain a firm grip on the tool with both
3.
hands to resist starting torque.
4. Avoid unintentional starting. Make sure you are prepared to begin work before
turning on the air supply or pressing the Trigger (27).
5. Never lay the tool down until it has come to a complete stop. Moving parts can
grab the surface and pull the tool out of your control.
Never leave this Air Nailer unattended when it is plugged into an air supply.
6.
Turn off the tool, and unplug it from an air supply before leaving.
WARNING: This product contains or, when used, produces a chemical
7.
known to the State of California to cause cancer and birth defects or other
reproductive harm. (California Health & Safety Code § 25249.5, et seq.)
For technical questions, please call 1-800-444-3353.
SKU 97526
95882
SERVICE

SPECIFIC SAFETY RULES

Page 4