OPERATION GUIDE
AUTO RUN MODE
The PLLEDST LED blinder allows to run an internal program simply
by setting the dipswitches on rear side.
Activate this function mode by setting the switches 9 and 10 on OFF.
The switch #1 controls the RED colour, the switch #2 the GREEN
colour and the switch #3 the BLUE colour.
The switches from 4 to 6 activate the strobe effect and control the
strobe speed.
SOUND MODE
Setting the blinder in Sound Mode, the projector will work in musical
mode. The blinder receives the acoustic signals by the internal
microphone. To activate this mode, set the switch #10 on OFF and the
switch #9 on ON.
DMX MODE
It is possible to control the device by a DMX controller.
To set the address of the projector, shift the switch #10 on ON
position. The switches from #1 to #9, are used to choose the starting
address of the projector.
The PLLEDST blinder is controlled by four channels.
CH1
RED
CH2
CH3
GREEN
BLUE
12
CH4
DIMMER e STROBE