Advertisement
FUncTiOn
REAR VIEW CAMERA*
SELECTSHIFT AUTOMATIC
The feature provides a video image of
TRANSMISSION*
the area behind the vehicle. The display
This transmission gives you the ability to
automatically appears in the touchscreen
manually change gears if you'd like. To use,
when the vehicle is in r (Reverse) and
move the gearshift lever from d (drive) to
uses green, yellow and red guides to alert
S (Sport). Then, press + or – buttons
you of your proximity to objects. For
on the gearshift lever to make shifts. if
non-touchscreen vehicles, the image will
equipped with steering wheel paddles, pull
appear in the 4.2-inch center stack display.
the right paddle (+) to upshift, pull the left
paddle (–) to downshift.
TILTING HEAD RESTRAINTS
To tilt the head
restraint, do the
following: Adjust
the seatback to an
upright driving or
riding position. Tilt
REVERSE SENSING SYSTEM*
the head restraint
forward by gently
This system sounds a warning tone if there
pulling the top of
is an obstacle near the vehicle's rear bumper
the head restraint.
when the vehicle is in r (Reverse) and is
Once it is in its forward-most position, tilt
traveling less than 3 mph (5 km/h). The
it forward once more to release it to its
warning tone will increase in frequency
upright position.
as the object gets closer.
note: do not attempt to force the head
note: Visibility aids do not replace the need
restraint backward after its tilted. instead,
to watch where the vehicle is moving. Refer to
continue tilting it forward until the head
your Owner's Manual for safety information,
restraint releases to the upright position.
more details and limitations.
14
MYKEY
*
®
®
Mykey allows you to program certain driving
restrictions in order to promote good driving
habits. You can program things like; speed
restrictions, limited volume levels and safety
belt reminders. For complete information,
refer to the MyKey chapter in your
Owner's Manual.
SECURICODE
KEYLESS
TM
ENTRY SYSTEM*
The system allows you to lock or unlock the
doors using the touchpad. You will need
your five-digit factory code located on your
owner's wallet card in the glove box. See the
Locks chapter in your Owner's Manual for
more information on how to use SecuriCode.
*if equipped
cOMFORT
HEATED FRONT SEATS*
note: This feature is operational when the
vehicle is in P (Park) and the liftgate has been
To access heated seats, press the climate
open for less than 10 minutes.
corner on your touchscreen. Press
repeatedly to cycle through the various heat
MEMORY FUNCTION*
modes and off. if your vehicle is not equipped
The memory function allows a "one touch"
with a touchscreen, press the hard button
.
recall of personalized memory features
EASYFOLD
REAR
®
including the driver seat, power mirrors and
FOLDING SEATS*
steering column* . Use the memory controls,
located on the instrument panel, to program
and then recall memory features. To program
position 1, switch on the ignition, then press
and hold
second position, press and hold
same tone sounds. You can now use these
controls to recall the set positions.
The controls are located near the left side
of the liftgate interior opening. Press the top
control to lower the right seat, or the bottom
control to lower the left seat. To return the
seats to their upright position, manually
rotate the seatbacks upward until you
hear a click and the seat latches.
PANORAMIC VISTA ROOF
AND POWER SUNSHADES*
The moonroof and sunshade controls are
located on the overhead console, and have
a one-touch open and close feature. To stop
motion during a one-touch operation, press
and release the control a second time.
To open, press and release the overhead
moonroof control
. The front and
rear sunshades will open entirely, and the
moonroof will stop short of the fully opened
position. Press
again to fully open.
until you hear a tone. To set a
To close, pull and release the control
until the
The glass panel will stop at the first position.
Pull again and hold to fully close the glass
panel. Pull and release the control to close
the sunshades. The
sunshades will stop short
of the fully closed position.
Pull the control again and
hold to fully close
the sunshades.
To vent from a closed
position, press the tiLt
control. To close from a
venting position, pull the
tiLt control.
®
.
*if equipped
15
Advertisement
